Your cart is empty.
Your cart is empty.NA
Ron Patterson
August 16, 2025
Works great and is easy to use.
toby mclawhorn
August 9, 2025
Easy to use
Poor communication
August 5, 2025
Awesome product works as it should
Chef476
June 29, 2025
This thing comes in two sizes. The only difference between the two is the rubber tube in the middle. It works ok. There are other better methods.
Biker Buck
May 6, 2025
It cut my setup time down to minutes from hours and I checked an engine that I had done just to find I was off by .050 so it is more accurate than the old way. Definitely worth the money because time is money.
Jack h.
May 2, 2025
This thing is accurate. I checked my geometry three ways. I did the die on valve tip and found a center mark with adjustable push rod. I did the 90 degrees to the valve at half lift theory and I used this checker.I did this specifically to check the accuracy of this tool and it is dead on
255D
April 26, 2025
easy to use gets you close good for amateur engine builders
Holmes
February 22, 2025
Great tool! I used with an adjustable pushrods and the marker method to check geometry. I didn't rely on this single tool but provides more confidence with other verification methods.
andre chaunt
January 19, 2025
good
Recommended Products
$162.91
$ 75 .99 $75.99