Shopping Cart

Your cart is empty.

Your cart is empty.

Race Ramps RR-72-2 2-Stage Incline Ramp

Free shipping on orders over $29.99

$477.00

$ 99 .00 $99.00

In Stock

About this item

  • Lightweight: easy to carry and maneuver, great alternative to Steel and lumber.
  • Strong: 100% solid core Construction
  • Safe: won't slip, slide, or scoot on any surface and never scratches or marks your floor.
  • A must for any garage: 8" Lift height is perfect for routine maintenance and Detailing. Ideal for any low-clearance vehicles.



Product Description

Race Ramps Gradual Incline Ramps (Pack of 2)

RR-72-2

Designed to work with low profile and lowered cars, 72-inch Race Ramps provide 8 inches of lift for better access to the underbody of your vehicle. These tough ramps are sold in pairs and can support up to 1,500 pounds each for a total vehicle weight capacity of 6,000 pounds. The two-piece design allows you to remove the ramp section once your car is up for better side access in showrooms or at shows. The raised lip provides a gentle stop.

The 12-inch width accommodates tires up to 10 inches wide. Positioning them or moving them for storage is easy; each ramp weighs 14 pounds and has a carrying strap. The initial angle of approach is only 6.8 degrees, which increases to 10.8 degrees.

Specifications

  • Sold as a pair
  • Measure 72" x 12" x 10" each
RR-72-2
RR-72-2

Two-piece ramps for service or display - no jack needed

RR-72-2

Tire stops prevent roll-offs

RR-72-2

Carrying handle for easy transportation

RR-72-2

Removable ramp section for better display

race ramps

Race Ramps Patented Construction

All Race Ramps products are 100% solid, made with high-density expanded foam and a rugged anti-slip coating. This patented process results in a product that is extremely lightweight, yet strong and durable. The ramps will not slide, scratch, or otherwise damage any floor type. They even work on ice!


Customer
2025-09-04 11:14:01
These things are really expensive but perfect for C3 Corvettes. Lightweight makes them easy to move around. They are durable and perfectly angled to prevent car damage. Also versatile for use during trailer load/unload. Nothing better!!
Justin Hughes
2025-08-23 18:00:44
Great for lowered cars. Works well with lowered 2015 Camaro SS 1LE and for Shelby GT350. Anything with a front splitter lower than 3.75 inches may scrub. 4 inches and higher will have no issues.
Greg R
2025-08-02 13:06:27
Purchase these to get under my 2019 Mustang GT premium which has lowering springs. They work very well, I'm impressed.
Venkata
2025-06-18 19:21:49
I needed to change oil on my 2017 Corvette Grand sport. The car is very low with ground effects packages.I found these ramps and read lot of good reviews about them, so I got them and I was not disappointed.I was able to drive onto them ramps without scratching the cars bottom. I felt confident as the the width was good enough to cover the entire tire. They were sturdy and did not move while I was getting the car onto them.Definitely felt safer then using jacks. I also used their stoppers on the back wheels just to make sure the car does not go back.Great product. I will keep using them and if I see any issue will make sure to re-review.
J
2025-06-12 16:59:31
Steel ramps had way too sharp of an incline for low end low torque vehicles, and I would nearly overshoot it. It was terrifying each time. I would scrape with the Sonata a bit even with a 2x10 pre-ramp and the RX-7 I didn't risk even trying.These are stiffer than I thought they'd be, which is relieving. No scraping because of the low angle, and it's not aggressive. I can gradually go up the ramps easily without flooring it then slamming on the brake to catch it when it levels out, like I had to do on steel ramps.I considered buying these a few years ago, but didn't...which wqs a mistake. Then I considered just stacking 2x12s and screwing them together, but they would've been so heavy and cumbersome. These 2 piece ramps are lightweight and easy to store and transport, unlike an equivalent wood-based ramp set would be. And steel ramps are no good for me.I'm very hapoy and they're worth the investment, to me, to have light, easily-stored, low profile ramps to do work on my own.
michael mossey
2025-05-15 15:18:18
They worked perfect for the my 2015 Corvette Z06.
KevO
2025-04-03 11:48:09
Arrived damaged directly from Race Ramps, bought directly off of them, not Amazon. They were both dented and scuffed up in several places and the lips of the ramps that you drive onto were folded over and compromised.Contacted Race Ramps support and they completely ignored me after responding once.
Josh
2025-02-10 10:37:12
These are well made & sturdy. Great for a lowered car or midsize truck with the lowest angle of approach. If you have a full size truck, even a short bed 2WD, though, you'll want to get the heavy duty 2 piece ones.