Your cart is empty.
Your cart is empty.Product Description
Snughome 20 Gallon Fish Tank Stand Aquarium Stand 2-Tier Storage Shelves
This aquarium stand is made of high-quality particle board combined with a sturdy metal frame. You can use it not only to place an aquarium but also to display flower pots or other decorations. Please confirm the size of your aquarium before purchasing.
Middle layer storage
The middle tier provides additional storage space for fish food, nets, disinfectants, water conditioners, and other daily necessities.
Suitable for 5-20 Gallon Fish Tanks
By using particle board support on the top, you can achieve greater stability when storing an aquarium or other items.
Product Details
Waterproofing
The particle board is made of waterproof material and is easy to clean.
Sturdy Frame
The fish tank stand is supported by sturdy iron pipes and particle board.
Iron Sheet Support
Four metal plates provide support, enhancing the stability of the product.
Adjustable Feet
You can adjust it to the right height with the help of adjustable feet.
Michael Deitz
2025-08-09 12:33:23
The most awesome thing I put together. Packaged real well, Labeled real well and instruction are good.
Mama & Brenna
2025-07-15 16:53:47
It's a little more flimsy then I would like. I think someone could fall into it and the tank might fall over. Definitely gotta secure to the wall.It wasn't hard to build and it did the job
Ryan smith
2025-05-18 16:37:29
Easy to put together. Took about 10 minutes
Nikki Adkins
2025-03-10 10:36:36
The media could not be loaded.
Shawn
2025-02-18 09:10:07
Definitely doesn't fit a 20 high
Mika
2025-01-03 16:59:45
I haven't filled up my aquarium which is a 22 gallon or so... the aquarium is half inch deeper than the table not much so my only complain is that the top table should have been deeper. Other than that it feels really sturdy
JC
2024-12-05 14:24:41
This product performs as expected. Assembly is similar to many other products from Amazon or made in China. It's well-made; all screws matched and fit properly. All screw heads were the same, which was convenient for using a drill to speed up assembly. However, I missed a step in the directions regarding the two side supports, which I installed backwards. Correcting this was annoying and took an extra 15 minutes. Make sure to follow the directions closely. I won't use this for an aquarium, but I tested it by sitting in the middle - at 220 lbs, it held up fine, suggesting it should meet its weight support claims.
Recommended Products