Your cart is empty.
Your cart is empty.Spicer 211750-1X Center Bearing
Hlee Xiong
September 6, 2025
great item. says toyota on it. perfect fit. now no more wobble on acceleration.
Joe Duval
August 3, 2025
This fit perfectly on my 2000 Tundra SR5 4.7 2X2, two piece drive shaft. The part came in a Dana Spicer box that said made in Japan however; the 10 digit Toyota Part number that was stamped on the actual carrier bearing is not recognized as a valid OEM Toyota OEM part and nobody seems to really know. I had to replace the entire drive shaft two years ago from an aftermarket company called the drive shaft store. I called them to inquire about the center support bearing AKA carrier bearing which was wasted in less than 10K miles and was advised it was beyond any warranty consideration.There drive shafts, yokes, and U joints all have Dana Spicer stamped part numbers so it's OEM Quality but the carrier bearing is some low quality import that's made in Taiwan however; when speaking with tech support they stated that the OEM and aftermarket bearings are all the same for this application which included their aftermarket drive shaft as well. Ths Dana Carrier bearing looked and felt to be of good quality which eliminated the hole shot vibration, under a load vibration and horrible bearing noise. There is no vibration at any speed or load plus there's now zero bearing noise whatsoever (HOORAY)!A few words to the wise for those who have the ability to do this repair themselves. #1 make sure to support the shaft with a jack stand when removing because if you let the shaft hang in the transmission at too much of an angle the transmission seal will leak upon reinstallation. # 2 make 100% certain to clearly mark the shafts, u joints and yokes so that they are installed back to the exact same position/location upon reassembly. I used a silver sharpie with two different identification marks for reference, because if you don't you'll end up having to buy another shaft due to excessive vibration, hope this helps.
John Trickle
July 28, 2025
Good quality part and perfectly replace the old carrier bearing in my 2014 Tacoma double cab short bed.
Customer
June 28, 2025
OEM Grade bearing. This main bearing is easy to install but you need to ensure you keep the shaft alignment when reconnecting. This has functioned flawlessly on my truck for over 3,000 miles.
jacob cohen
June 28, 2025
If you're here, just buy it. You know.
Alburn Rolle
June 24, 2025
Spicer 211750-1X Center Bearing OE Identical Part as Toyota 37230-35130. Fit PERFECT with no Issues on a 2003 Toyota Tacoma 4 Dr. 3.4l. Same quality at an unbelieve & unbeatable price. You will not be disappointed!!!!!!!
Vincent Bowen
June 19, 2025
Pretty easy to install if you have some basic knowledge on working on vehicles. Fixed my driving issues!
Bryan Patrick
June 16, 2025
I replaced the center drive shaft support bearing on my 1996 Toyota Tacoma with this bearing. It was an exact match for the original.
Dirty Danchez
May 7, 2025
Direct Replacement on my Gen 1 Yota.
Moises L.
March 4, 2025
Ya era necesario el cambio para mi Toyota Tacoma 2004 4x4. La calidad 10/10 se notó el cambio y más por que lo necesita urgentemente.
Joe
February 3, 2025
They work
Scott Birnie
November 24, 2024
Fit my 2006 tundra double cab 4x4 but don’t have the seals on the bearing like the original toyota one did but it works great so far been installed for 3 weeks
Recommended Products
