Your cart is empty.
Your cart is empty.Product Description
Steel PIN GAGE Set Plastic CASE M0,M1,M2,M3 Style Set
- For checking hole diameter and diatance between holes and hole location.
- Heat treated to a hardness of 60/62 RC
- Tolerance: All gauges with .0002'' minus
- Overall length 2'', all members 2'' long, centerless lapped
Steel PIN GAGE Set Plastic CASE (PIN-M0-50) 0.011''- 0.060'' X 50 Pcs
190 PCS M1 (0.061-0.250") Minus Steel PIN GAGE Set Plastic CASE
250 PCS M2 (0.251-0.500") Minus Steel PIN GAGE Set Plastic CASE
LLDSIMEX 125 PCS M3 (0.501-0.625") Minus Steel PIN GAGE Set Plastic CASE
Wesley Jansen
2025-07-31 10:50:05
These seem very accurate, use them often at work. No issues found
Gunner
2025-07-25 11:51:45
As a life long machinist I will say you need to measure them yourself, but if you are a professional like me then you already know that. They worked okay for what I needed them for which was measuring very small orfice jets hole size.
pappygo lucky
2025-06-21 18:02:16
I glued a magnet to the inside bottom of the case. It keeps the tools from falling out. Holds them securely. The tools are accurate, I measured mine with calipers and again with a micrometer. The holder is clearly marked however my tools are not. Used for measuring carburetor jets.
JAMES E RIBBLE
2025-06-16 14:18:58
Worked good
Danielle Dulyea
2025-05-28 15:46:02
cheap
DWG
2025-05-02 19:57:44
Great product. Very precise. Used for fuel injection for cars and worked great.
Grace Ferris
2025-03-04 17:32:50
Great
Ralph
2025-02-11 11:40:29
Steel PIN GAGE Set Plastic CASE (PIN-M0-50)The product arrives sealed and protected against air. The case securely holds the product in place and cannot be accidentally opened. I am not a huge fan of the case because you cannot easily pop it back on with one hand. You have to hold it and pull the tab back to put the lid on.The pins come adequately oiled to ensure a long life. In this case, there is good spacing between the pins, and you should have no issues pulling them out and putting them back in. I am particularly talking about the smallest pins.Testing:I tested the largest pin in the set (0.06") and the smallest (0.011") as well as a random sample of pins. All the pins are true to their value of being SLIGHTLY less or MINUS pins. I only have equipment to test within 0.0005" and during my testing, I will say from visually subdividing measurements, this product meets its tolerance of minus 0.0002". No pins in this set were LARGER or PLUS the value stated.In addition to a one point measurement of the pin diameter, I tested the pins for consistency throughout the entire pin by measuring 3 points and rotating the pin throughout. I have found some slight variation in the pin, but still within the 0.0005" capability of my measuring equipment. I want to note that this is normal in professional pins as well.Overall, I think this is a very good economical set of pins. Like always, pins should be calibrated regularly based on the frequency of their use. I recommend this product.
Recommended Products
$135.99
$ 66 .99 $66.99
$119.99
$ 52 .99 $52.99
$109.00
$ 43 .99 $43.99
$24.83
$ 12 .99 $12.99