Your cart is empty.
Your cart is empty.Product Description
A HILLMAN assortment of push nuts for unthreaded rods, axles, and rivets with variants sized to fit parts 3/16" thru 3/4" in diameter. Push nuts have an unthreaded, inward facing flange meant for quick, tool-free installation. Push nuts are meant to be used as permanent connection pieces once set in place. Full assortment contains thirteen (13) refills comprised of HILLMAN item numbers #884 - #894, as well as #45632 - #45633.
From the Manufacturer
These Axle Cap Nuts offer easy installation for permanent applications. With an inward-facing flange, the nuts can be pushed into place without using tools. They are non-threaded, and corrosion resistant.
Shizzel
2025-07-27 10:19:16
Perfect fit. Made a 14' rolling fence gate for my driveway added two axels 5/8 th and wheels to roll open and close, capped rod ends with these caps worked great and still holding strong. Works better than drilling a hole in axel and cotter pins. Looks good on wheels.
mary wells
2025-06-20 17:11:14
Used to replace my wheels on the garbage can, Because I had to remove the ones holing to old wheels I got these to replace the old so my wheels wouldn't fall off on the way to the road. They worked well and easy to install.
SwampFox
2025-06-08 17:57:50
Worked great for my 5/8" handcart axle. Boughtvwith new tires
Steven C.
2025-04-26 10:27:45
Replaced a roller on a boat trailer and needed these axle cap nuts to cap off the rods that support the roller. While I did eventually get them to hammer on, they were definitely a bit undersized thus making it more challenging than it needed to be. All-in-all, no major complaints, but I'll look for another brand next time.
Customer
2025-03-29 18:51:05
We have some over zealous trash men...Sorry, waste management professionals. They toss our recycle and trash containers, that have wheels on them, so hard that the wheels fall off. The first time it happened, I thought I would have to spend a bunch of money to replace the container, but I did some researching and found these. Just put the wheel back on the axle and hammer one of these on the end and you're done. I fixed my neighbors container last time....Now I'm the hero of the neighborhood ;-)
Customer
2025-03-11 18:55:14
The fit was right and the count was correct, the box says " made in USA"
Dbar
2025-01-11 17:05:36
I used for a small boat trailer - later tried to modify and the suckers wouldn't come off!! had to hammer it! would def buy again - very strong and held the wheels on tight!!
Joseph LaFreniere
2024-11-21 21:43:22
As described fair price....galvanizing was goodeasy to use...used on trailer rollers....to secure rod that holds rollers
Recommended Products
