Your cart is empty.
Your cart is empty.Product Description
Miguel
2025-08-08 14:23:03
Muy buena
Russell bennett
2025-07-08 16:56:36
got first one and screw stripped out on electrical got it replace with not problem and ran compresser twice and switch stuck in the on position so returned it and got money back
Craiger
2025-05-06 17:30:00
It was a struggle to get this switch installed as a replacement for the Condor switch which was on my compressor. This one was actually a few dollars more expensive than the Condor switch but had a faster delivery so I went with it (live and learn !). First off, the wiring block is a bad design and poorly positioned. It's a very tight clearance between where the cables enter and exit the switch and getting access to the terminal screws and the grounding screws. The biggest problem was connecting the tubing. My existing tubing from the Condor switch is 0.25" (standard and most common) but this switch accepts 0.20" tubing (I assume 5 mill). Luckily I was able to shave down the outer diameter of the 0.25" tubing and force it to fit. So far it's staying in place but the compressor has only cycled twice since installing. If you're replacing a Condor switch I would not recommend this as an equivalent replacement.
Vito Virgili
2025-05-04 13:29:43
This is the second one that has the same problem, the 1/4" fitting is to small for 1/4" U.S. standard tubing
DesertMark
2025-02-08 17:32:25
Pressure tube size on compressor larger then fitting on switch
Recommended Products