Shopping Cart

Your cart is empty.

Your cart is empty.

uxcell 13 Inch Hammer Wooden Handle Wood Handle Replacement for 2 to 4 Lb Hammer Oval Eye 2 Pack

Free shipping on orders over $29.99

$15.09

$ 6 .99 $6.99

In Stock

About this item

  • Good Replacement - 13 inch wood replacement hammer handle for 2 to 4 lb set of 2
  • Durable Handle - Made of hardness oak wood, with clear lacquer surface wax finish, durable long lasting life
  • Ergonomic Design - Ergonomic handle design, more ergonomic and labor-saving, natural wood feel, comfortable to use
  • Wide Application - This wood handle design for sled hammer, claw hammer, tack hammer...
  • Install Size - Oval eye shape 0.87" x 0.59"


13 Inch Wood Hammer Handle Replacement 2 Set Oval Eye
Feature:
Easy replace your broken handle directly, with a good match.
Use hardness oak wood, ergonomic design, with comfortable hand feel, shock absorbent and durable.
Set of 2 will be more cost-effective, As a backup in case of emergency need
Wide use for most of the popular hammers, can diy your own hammer by yourself.
Specification:
Product Type: Hammer handle
Handle Material: Oak wood
Handle Length: 13 inch (32cm)
Weight: 0.281lb(129g) each
Eye Size: 0.87" x 0.59"
Application: sledge hammer, club hammer, claw hammer, cross peen hammer, tack hammer...
Package Content: Set of 2 wood handle replacement 13 inch
How to replace?
1. Drilling out the broken handle from the old head
2. If the handle eye is bigger than your hammer head, You should trim off a bit of wood on each side of the replacement handle shaft until it would tightly fit into your hammer head
3. Finally, you need to pound the handle into your old head, to make sure it tight fit your hammer
Please Note:
Read the description to make sure the product will fit your need


Bob T
September 4, 2025
I bought this handle set because they included in the description the size of the end that goes in the eye of the hammer. I had to sand it down a little bit and was able to drive it on. I had an old wedge to drive in the end to hold it in place. Wish they had included wedges with the handles. It feels good and sturdy and kept an old hammerhead from being thrown out.
rich
May 28, 2025
Too short for a 4lb. Hammer
gjrnd1
May 26, 2025
Bought these to replace/repair old, damaged claw hammer handles. These handles are ok quality-wise, a bit lightweight, but too small. Contrary to the description, these do not fit my 2 lb heads. Would fit a small ball pean or similar head. Not worth the effort to return so I’ll hang onto them until I find a use.
JoyC
May 19, 2025
Excellent replacement for broken hammer handles
Melissa A. Tanner
May 4, 2025
When I tried to put the handle in the hammer head the first one split. Have not tried the 2nd one yet.
Jamie
February 12, 2025
easy to replace
Pierre Hébert
February 11, 2025
Bon produit
Steven
February 6, 2025
Way too small of a handle for a typical claw hammer replacement. These are meant for very small hammers