Your cart is empty.
Your cart is empty. Description:
Needle Roller Thrust Bearings provide a high degree of stiffness within a minimum axial space. It has a smaller cross-section than a standard thrust bearing for use in restricted spaces.
These bearings accommodate heavy axial loads and peak loads due to the small diameter deviation of the rollers within one assembly.
Thrust Bearings can be combined with washers in applications where adjacent components cannot serve as raceways.
Chromium steel rollers for heat tolerance and durability under heavy loads; Steel cage guides and evenly spaced rollers for reduced friction, vibration, and noise.
Rolling bearings are used in a range of applications from agricultural machinery to conveying equipment, robotics, elevators, rolling mills, ship rudder shafts, and aggregate crushers, among others.
Jason
2025-08-23 19:39:36
I was paying over $25 for 2 of these from other suppliers. Quality it's good. I'm using in a racecar coil over spring application, so pretty abusive environment and so far so good. Enormous cost savings.
Linda B.Travis
2025-08-15 16:34:02
I used this bearing on the seat pivot on Acorn stair chair. Fits great and reduced chair swivel force. Great improvement especially after lubricating the sleeve solid bearing with lithium grease.
Jaime Lugo
2025-07-23 15:22:05
Works like a charm. Comes with enough shims to make up any gaps you may need for a tight fit.
Jack
2025-07-20 13:08:50
listed incorrectly and unable to get a refund. will only send you two bearings, 4 races.
Dave Parker
2025-06-01 13:38:08
Received these packed in a plastic bag inside a small box. No apparent damage to the box. I ordered these thrust bearing expecting them to be a little beefier. But they are pretty light weight and several were on out of round or egged shaped. One roller bearing was missing and found it inside the plastic bag. Contacted Amazon and they refunded my purchase. Without the return, I would have given a much lower rating.
William F Bonneau
2025-01-10 12:24:15
Not the finest quality, but it did work.
Joey ðŸ»
2024-12-25 12:42:43
You can't say much about bearings, they're sized properly and are made of the correct metals. The bearing seats are precise and allow them all to rotate smoothly and they're reasonably priced. Always a perfect combination
Recommended Products
