Your cart is empty.
Your cart is empty. Specification:
Model: RC081208
Drawn Cup Material: ST14 Steel
Needle Roller Material: Chromium Steel (GCr15)
Bore Diameter (Fw): 1/2"
Outside Diameter (D): 3/4"
Width: 1/2"
Torque: 7.9N*m
Number of Pack: 5 Pcs
Description:
-Drawn Cup Needle Roller Bearing features a deep drawn, thin-walled outer ring. They are compact bearings with high load carrying capacity and stiffness.
-These bearings are especially suitable for high dynamic loads or radial-limited installation. They are mounted with a tight interference fit in the housing.
-Shoulders or snap rings are not required to locate the bearing axially, thus enables a simple and economic design of the housing bore.
-For various applications such as agricultural and construction equipment, pumps and compressors, and two-cycle engines, among others.
-NOTE: Install with press machine or special tools instead of hammers because beating may lead to local deformation.
Donald B.
2025-08-11 16:31:11
Good
ThePlayer
2025-06-28 16:10:12
These are great one way needle bearings I'm using them for starter motor on an antique motorized bicycle
Jeff W.
2025-06-11 16:18:39
These fit like a charm, just wish I would have read the one way part beforei put them in....lol
Chuck
2025-05-18 16:01:52
These are very nice Bearings. Perfect fit!!!
Crafty-Mechanic
2025-02-22 18:03:49
Out of the bag, 4 of the 5 bearings would only turn in one direction. In the other direction, they would lock against the shaft and bind up. If you are using these for one direction of rotation, might work, but carefully check before installing them. I returned them.
Samatha
2025-01-31 11:54:01
These bearings only roll in one direction . The lock if you try to reverse the directions
Recommended Products
