Your cart is empty.
Your cart is empty. Description:
Plain Bearings are constructed with carbon steel as base, sintered porous bronze as its interlayer, rolled with PTFE and Lead compound as inner surface, and copper-plated on the outer surface.
Wrapped Bushing is self-lubricating. It offers good frictional property, wear resistance and low noise.
Solid friction Oilless Bushing can operating during wide temperature rang. Suitable for applications with sliding movements.
Oilless Sleeve Bearings are most suitable for place where self-lubricating properties of the material are required.
Note: Split Line can not be used for bearing.
Specification:
Material: Carbon Steel Base with Porous Bronze Sintered
Finish: PTFE and Lead Rolling, Copper Plating
Friction Factor (Dry Friction): 0.04-0.2
Friction Factor (Oil Lubrication): 0.02-0.07
Bore Diameter: 12mm
Outside Diameter: 16mm
Length: 20mm
Number of Item: 2 Pack
M. F. Guilbault
2025-08-29 11:19:44
These sleeves fit perfectly as a non lubricated bushing. The dimensions were spot on.
Bob K
2025-08-28 11:49:11
There's not much one can say about a Sleeve Bearing... except that it's a Sleeve Bearing. I see now that the description says "wrapped" which I assume means that it started out as a flat piece of metal that was bent into the cylindrical shape. That wasn't obvious from the picture or description, and wasn't what I was expecting. There is only a hint of a seam in the picture. The seam on the bearings I got is obvious.Having said that, I don't know that a seam is going to affect the products performance or durability. There wasn't enough of the previous Bearing/Bushing left to know if it had a seam.
Dr D
2025-08-26 09:17:43
I have a Ryobi BE-321 belt sander. You can't buy many parts for it any more. My main roller bushings were worn, causing the belt not to track properly. Replaced the bushings with these and it works great again.
Michael
2025-07-06 10:37:47
Used it to adapt my abrasive cutoff saw arbor to take 5/8" discs.The sleeve isn't a solid construction, but appears to be sheet steel with sintered bronze coating rolled into a tube. May or may not be appropriate based on your application.
Dave Keiller
2024-12-11 11:27:01
These are what I expected and will serve the intended purpose thanks.
Recommended Products
