Your cart is empty.
Your cart is empty. Specifications:
Material: Sintered Bronze
Bore Diameter: 8mm
Outer Diameter: 12mm
Total Length: 15mm
Package Contents:
3 x Sleeve Bearings
Description:Sleeve bearings are also known as plain bearings or bushings, mostly for guiding or reducing friction in linear applications. Oiled Bearing Sleeves have a small friction coefficient of about 0.12-0.18.
They are made of powder-metallurgical metal, which has a large working temperature range from -80 degrees Celsius to 120 degrees Celsius.
Bushings provide strong housing for a shaft or fastener. They also help to reduce bore diameter or to replace worn-out original bushings on wheels.
Sintered bronze bushings are most suitable for applications with rotating movements and where self-lubricating properties of the material.
Suitable for a vast variety of industrial equipment such as electrical equipment, household equipment, printing machinery, and machine tools.
Customer
2025-09-07 16:02:34
Good quality and finish
Jason D.
2025-08-26 17:53:06
Swapped my 6.0 starter for the 6.7 starter (best upgrade I’ve ever done) You’ll need one of these for one bolt hole that is slightly bigger than the other two. Don’t think about it just make the swap. Starts up in one second now. No more long cranks
P. Stanton
2025-08-11 12:49:50
This is very close to having the same dimensions as the original bushing, with the exception of being 1mm longer. I checked to be sure the c-clip retainer would still fit on the installed shaft and it does- I left off one of the thin washers that go at either end of the bushing and it leaves enough play to let the shaft spin freely.
Laureen Doyle
2025-08-07 13:38:48
Did what was to do!
408 LS Stroker
2025-07-19 14:30:58
Perfect for the 6.7 PSD starter upgrade on a 6.0 PSD. Got it installed , cranks over super fast now.
Hunter
2025-06-07 17:14:05
worked
Patriotic Rottweiler
2025-05-18 11:55:28
This is the bushing that you need if you are upgrading your 6.0 PSD to the 6.7 PSD starter. It fit perfectly.
Newman Vu
2025-03-22 13:48:25
Used these to install a 6.7 starter in my 6.0
Blue900Custom
2025-03-10 11:23:22
I ordered those bushings to repair our Sunbeam bread maker. Took a bit of work to get it apart but they were a perfect fit and got the machine working again. I would recommend these and would purchase again
Daniel
2025-01-30 16:56:56
Bought this because I was doing the 6.7 starter upgrade to my 6.0. works as intended and fits perfectly. couldn't be happier.
Recommended Products
