Your cart is empty.
Your cart is empty.
Description:
- Plain Bearings are constructed with carbon steel as base, sintered porous bronze as its interlayer, rolled with PTFE and Lead compound as inner surface, and copper-plated on the outer surface.
- Wrapped Bushing is self-lubricating. It offers good frictional property, wear resistance and low noise.
- Solid friction Oilless Bushing can operating during wide temperature rang. Suitable for applications with sliding movements.
- Oilless Sleeve Bearings are most suitable for place where self-lubricating properties of the material are required.
- Note: Split Line can not be used for bearing.
Specification:
Material: Carbon Steel Base with Porous Bronze Sintered
Finish: PTFE and Lead Rolling, Copper Plating
Friction Factor (Dry Friction): 0.04-0.2
Friction Factor (Oil Lubrication): 0.02-0.07
Bore Diameter: 8mm
Outside Diameter: 10mm
Length: 15mm
Number of Item: 6 Pack
Leonard Schmick
September 1, 2025
I used the sleeves as bearings and reducers on each end of these pull up straps. They worked perfectly to reduce the size of the holes and allow the straps to swivel. Very happy with this product..
CYBER BEAR
August 22, 2025
These are great bushing I used in mounting a hydraulic steering dampener on my gas powered scooter, as shown in the picture.I recommend this product.I recommend this product and have nothing negative to say about it.
Customer
August 2, 2025
Sleeve bearing exactly as described
Customer
July 19, 2025
used to bushing a bearing. did exactly what i needed it to do.
Mark McConnell
July 16, 2025
These were a great piece which allowed my moped's new rear suspension to fit on the old bolt without buying official adapters.
paul
May 28, 2025
suppose to be 8 mm but the 8 mm bolt is very sloppy would not buy again.
Leonard Schmick
May 13, 2025
I used the sleeves as bearings and reducers on each end of these pull up straps. They worked perfectly to reduce the size of the holes and allow the straps to swivel. Very happy with this product..
CYBER BEAR
April 24, 2025
These are great bushing I used in mounting a hydraulic steering dampener on my gas powered scooter, as shown in the picture.I recommend this product.I recommend this product and have nothing negative to say about it.
Customer
March 7, 2025
Sleeve bearing exactly as described
Customer
January 12, 2025
used to bushing a bearing. did exactly what i needed it to do.
Mark McConnell
December 21, 2024
These were a great piece which allowed my moped's new rear suspension to fit on the old bolt without buying official adapters.
paul
December 11, 2024
suppose to be 8 mm but the 8 mm bolt is very sloppy would not buy again.
Recommended Products
