Your cart is empty.
Your cart is empty.
Compatible With
- 1987-1996 Ford F150
- 1997 Ford F150 Old Body Style
- 1987-1997 Ford F250
- 1987-1997 Ford F350
- 1987-1996 Ford Bronco
Fit for both Front Left & Right Inner & Outer
Note: Please check the part number before buying to make sure it fits your car
Note: It is recommended to align all the clips of the 4 window seal with the holes to determine the position of each window seal before installation.
Note: There is a tough steel bar in the curved part. If there is some disobedience, it can be knocked down with a rubber hammer, which can be corrected, or wrapped in a towel with a wooden stick and knocked down.
About Us
Our products are 100% brand new quality products, welcome to buy. With our best products and best services, we believe this will be a pleasant shopping experience.
We care about our valued customers and hope to establish a long-term business relationship with you, so please help us do better.
Quality Assurance
1. Each item has been factory tested and meets or exceeds oem specifications.
2. Provide lifetime warranty service. If you are not satisfied with the product or the product has quality problems, you can contact us at any time, we will provide you with a satisfactory answer and solve the after-sales problem for you.
We attach great importance to quality and service. If you have any questions about the project or our services, please contact us first. We value your feedback, so we will strive to answer all inquiries within 24 hours.
thebboshow
August 26, 2025
I installed these on my 1987 F-250 without much issue. Only issue which wasn't the products fault was my door panels were warped and slightly broken from being in the AZ desert it's whole life. Install went fairly smooth. After install I used some silicone spray lube the window glass. It gets tight after installing. If you window seals are junk it would be a good time to replace them all.
Firfyter
July 26, 2025
This fit my 1986 F350 front doors perfectly. It does not fit the back doors, only the front.
nc_beagle
July 10, 2025
I'm typically ok at fixing things like this. My old window sweeps on our 1996 F-150 were dried out and cracking on the exterior side so I decided to replace them. These actually seemed nicer than the OEM and I was excited to get them installed.Removing the old ones was a little harder than I expected and I ended up using needle nose pliers to pull them out. I did watch a YouTube video so I could see how they were attached to the vehicle. These sweeps were maybe 95% the same as what I pulled out with the primary difference being at the "back" of the window--the side closest to the lock.The problem I had was that I got the exterior driver's side installed but something wasn't quite right, so I pulled it back out. I couldn't do it with my fingers so I returned to the pliers. I got it out, but bent it a lot when it came loose. Getting it reshaped into a straight line was pretty difficult. I could get it straight enough to reinstall, but it was obvious along the outside of the window that I had not gotten it perfectly straight.Ultimately, because they were relatively inexpensive, I just ordered another set. I was more careful the second time and now everything looks good--far better than the dry-rotted ones I removed.My only other complaint isn't with the product itself but the design from Ford. The retention clips that catch inside the door frame don't make an audible "click" or give any touch-feedback that they are actually clipped-in.
Francisco A Davila
June 17, 2025
Excellent quality of material, perfect with the exact measurements and easy to install and fits very well on my car
Anonymity ;)
June 11, 2025
Bought this for my 1996 Ford F150 4x4 XLT. This product is slightly smaller in size, lower in quality, with clips that don't grab the same as the factory ones. It's like running a marathon, then just before you get to the finish line, you stop and go in the opposite direction??? The weatherstripping that attaches to the outside of the window glass almost snaps right in place, decent fit. The inner piece of weatherstripping however, well, good luck with that! Push it in place and the dam thing pops back out. Over and over no matter how you try to adjust it, reposition it. The clips are not big enough, and don't have enough "bite" into the door trim holes. I do not recommend this product for a 1996 Ford F150 4x4 XLT. Try other quality companies. Hope this helps.
John R.
May 7, 2025
Will wind up gluing them in place otherwise nice seal
randy bentley
May 6, 2025
Good product
Cody Freeman
April 22, 2025
snapped right in did have to bend the rounded ends to match the door but it was easily done by hand
David
February 20, 2025
Anorher fantastic quality product
Cecilio J.
February 5, 2025
Encaja a la perfección, remplazo de pieza original
Pedro
January 6, 2025
Que muy bien de muy buena calidas como originales
Douglas
January 5, 2025
Fit perfectly
Recommended Products
