Your cart is empty.
Your cart is empty.WORKMAN DXX CB RADIO MOUNTING BRACKET
Gerard B.
2025-07-10 14:57:46
Nice and rigid. I use these with washers and spacers to prevent separation of the sound board from the main board. Flimsy brackets damage your radio over time. This one will not if you do what I did and put proper spacers between your radio and the bracket. I'm including my installed photo in my peterbilt 379.I've included photos to show the position in my truck. The second photo shows the nylon spacer I used to compensate for the width of the bracket.I also have a Bluetooth speaker velcroed to the top of my CB and some stuff hanging there. The bracket is tall enough to put in more than one radio, and also great if you have an external meter or anything else you want up there.
derek fuller
2025-06-09 11:23:29
Sturdy mount and just the right size for what I needed!
Micky Jones
2025-06-05 15:23:59
Good strong bracket. I Good Strong a second one.
J Torres
2025-06-03 17:44:07
This Mount is very solid and rough , if are you planing to permanent install your radio , this is for you!
Aaron Knowles
2025-05-28 10:43:27
Na
Ryan Sanford
2025-02-26 17:31:34
Note that this is about 3/4 inch wider than a car stereo. Had to shin, but worked for my needs
Alex McCarthy
2024-12-30 10:26:27
There are a few reviews on here of people receiving the DXXX instead of the DXX. The same thing just happened to me - so apparently this company has not fixed the problem. It is a very nice bracket though, I guess I will have to take a Dremel to it, to knock off three or four inches.
R Goodman
2024-12-24 18:04:43
No problems and well built
Recommended Products
