Your cart is empty.
Your cart is empty.
1.Guarantees display readability,easy to clean and wipe off dirt.
2.Seals existing scratches underneath,makes the cluster screen like new again.
3.Good scratch and corrosion resistance, anti-glare protective lenses will reduce reflections.
4.Waterproof, shockproof, anti-lightning, resistance to high pressure
Pete
August 25, 2025
The protector is not a 100% fit and I can live with that. I think it is an ok product.
Randall S.
August 9, 2025
After reading reviews from others saying they were cut too small I was a little hesitant to buy these. But I'm glad I did because these fit my 2018 z900rs cafe perfectly. I also didn't know that it comes with a third piece for the digital screen in the middle of the pods. Cheap protection, a must have.
Joe T.
July 15, 2025
Don't buy!!!! The kit I got is not cut to correct size. It's over. The little console area is not cut to size.
Jp
July 12, 2025
Not a perfect fit, it's a little bit smaller. This would have been a good product if it was sent properly packaged. One of the screen protector was bent, and now after install, that corner won't stay on!
Jebb
July 4, 2025
They're fine for what they are, but the instructions are a little confusing. I also have not been able to get bubbles out completely even though I installed them very carefully. I'd rather have bubbles than scratches though.
david n.
June 14, 2025
Very easy to put on and the kit has everything you need to do a professional job
Eric Brennan
April 29, 2025
Fairly easy to install. Most of the bubbles disappeared that I wasn’t sure if they were going to. Plan on keeping this bike along time so it would seem to be a good investment to keep my gauges and LCD screen from getting scratched.
Steve J.
March 30, 2025
Great solution to prevent future scratches on the dash readout.
Cyber Mind
February 25, 2025
The fit is perfect on my Kawasaki Z900rs. The bike has two analog gauges and a center digital display and all protective film sections went on without any issues. However do not try to stick them on dry per included instructions. You need to use a PPF solution (alcohol, distilled water) if you want to eliminate air bubbles.
Steve Meagher
November 19, 2024
Round gauge clusters fit perfect. Instrument panel in between was a bit off. Close enough for me, but not 100% perfect.
kurtman
November 15, 2024
They are cut to perfect size. Cover my speedo tach and center gauges well. Are a great product. Would recommend. And just make sure to clean well before applying
Recommended Products
