Shopping Cart

Your cart is empty.

Your cart is empty.

WWZMDiB Peltier Cooler Module Kit 12V 40mm x 40mm(1 TEC1-12706+1 Heatsinks+1 Fans)

Free shipping on orders over $29.99

$8.99

$ 3 .99 $3.99

In Stock

About this item

  • The temperature of the hot surface of semiconductor refrigeration should not exceed 60 ℃, otherwise there is a possibility of damage.
  • TEC1-12706 Semiconductor Refrigeration Tablets:It is made of ceramic substrate 12V 6A 60W Assemblypressure 85N/cm2(40 x 40 x 3.7mm)
  • Aluminum Heatsink:Back Side Thermal Conductive Tape(40 x 40 x 11mm)
  • 4010 Fans:12V 6512+5%RPM(40 x 40 x 10mm)
  • Unsure of hot and cold sides 1 Pcs 1.5V battery can be used to test


WWZMDiB Peltier Cooler Module Kit 12V 40mm x 40mm(1 TEC1-12706+1 Heatsinks+1 Fans)


Ken Bessler
2025-06-05 13:37:12
These are very inexpensive but the parts are well made. My only issue was the ability of the heatsink/fan combo to help the cooler work. They are too small for the load. I ran them together at 12 v but the cooler soon overheated with a negative delta. I ran the cooler at 6 v and the fan at 12v and was able to hold a delta of 25-30c. They are rated for a delta of 60c and for that you need a much bigger heatsink and fan.Still, for the price I bought three and I don't regret it.
Mechanical Engineer
2025-04-15 15:11:52
Absolute garbage. Heat sink and fan totally useless.The fan runs on 12 volt and .05 amps (.59 watts).I tested the TEC at varying voltages and currents.Maximum before overheating was 12 volts, 3 amps (32.5 watts), where the cold side got to 103 F, which was much warmer than the ambient air temperature of 82 F. The hot side got to 196 F.At 1 and 2 amp input the best delta T that I saw was 10 F below ambient room temperature.The screws that hold the fan on do not hold the fan on, they screw into nothing.I tried the fan in both directions (blowing towards the hot side and away from the hot side) and it made no difference in the thermal camera temperatures.The cold side is the one without any printing.
Brayton Fish
2025-04-01 16:20:54
Definitely doesn't have a big enough fan or heatsink. The unit shuts off after about 10 seconds. Very useless unmodified. Would have been 0 stars but im hoping it's not broken, so I can fix the overheating issue.
Robert Mech
2025-03-01 10:33:18
Fan is not held securely, blows out instead of in based on picture and doesnt mount well the proper direction (or any direction) Peltier works fine.
John
2025-02-25 15:05:23
Both sides get hot. I rigged a water-cooled version using the heatsink, and was able to get one side to cool. But either a bigger fan or bigger heatsink is needed for anything to cook.
enmanuel garcia
2025-02-07 18:58:41
Exelente producto,se los recomiendo.