Your cart is empty.
Your cart is empty.You have an XS Scuba Standard Pressure Gauge or Brass & Glass Pressure Gauge (SKU's: XSSPG and XSSBPG) and want a Protective Rubber Boot. XS Scuba's Pressure Gauge Boot is designed for Gauges measuring approximately 2.5" x 1.0" (6.4 x 2.5 cm) in Diameter x Depth, and is made from Durable Thermoplastic Material with Left and Right Side Attachment Points for a Clip or Lanyard.
Danni
2025-08-23 13:54:26
It's a hard plastic so at first I couldn't get my SPG to fit. Posted a question and quickly received a response that you need to drop it in boiling water for a bit to make it flexible. Boiled, slid in SPG, fit like a glove and then it cooled back to harder plastic again! Very happy with it!
Wmssurf
2025-08-22 10:14:25
My 2 inch HOG gauge fits but it is a little loose and wobbles in the boot.
Rick May
2025-08-01 14:54:31
With a wrist based computer, I no longer need a three gauge console. Fits an older Genesis SPG with a diameter of little over 2â€. For the boot to fit, I boiled the boot for about a minute.
Goose
2025-07-24 10:07:14
Tight but good snug fit once you get it on. I squeezed a 20 year old Oceanic SPG into it when changing to a wrist mount comp with transmitter. It feels more like plastic than the usual harder rubber material that’s typical of a lot of scuba gear. I had to use a hot water soak before I could get it to fit but it worked and it’s been great on the past 5 or so dives.
SPARTANWARRIOR
2025-07-22 10:26:37
If you have a dive computer and you stop using a depth gauge like one person who posted here, THAT IS THE WRONG ANSWER! ALWAYS USE REDUNDANCY! DIVE COMPUTERS BREAK AT DEPTH, SO YOU WILL ALWAYS NEED A DEPTH AND A PRESSURE GAUGE! DON'T LISTEN TO ANYONE WHO STATES OTHERWISE.
David S
2025-06-09 09:24:46
Having finally purchased a dive computer, I no longer needed the depth guage on my old US Divers console, which was large, heavy, and cumbersome. I looked at getting a new pressure guage alone and couldn't find one for less than $75.00. Then I found this. I ordered it after carefully measuring my gauge. It fit perfectly, with a bit of persuasion, and cost a lot less. Combined with a wrist compass, I now have all I need in a much more streamlined package.
Customer
2025-03-21 18:48:03
no problems
Cut-AWAY
2025-03-02 17:23:37
Does not fit ScubaPro 2" SPG properly and is a tad too small in dimension...
Erick S.
2025-02-15 14:04:21
I used this to put a 2" pressure gauge as I wanted to get rid of the extra unnecessary depth gauge. However, it took a little persuasion when installing it. Plastic is hard and had to put it in hot water for 5 min before I was able to gt the gauge in. Once is in, it's solid. I really like the little corners to hookup a double ended snap. Great product.
Recommended Products
