Jacob Sanchez
2025-08-05 10:28:17
I liked how quickly I got my order after placing it. Interchangeable with other equipment is another plus. Thank you for a great product!
David
2025-08-02 12:46:50
I purchased 2 motors, and they both work really good. The bad part was the poor packaging. The red wire on one motor was badly pinched almost looked like the wire was broken inside of the insulation.
F. Kepley
2025-07-26 15:17:48
This is a solid motor and runs good on 12v also if you need lower RPMs (only draws 1 amp at 12v with no load). If you intend to put a timing pulley, pinion or any other kind of mechanical interface on this shaft instead of using the chain sprocket that comes on it, then at first it may appear that the usable 8mm portion of the shaft is a miniscule 3.5mm long. Luckily this is not the case, there is just a bushing that you need to remove to gain access to the full 8mm shaft length. Once the bushing is removed you have 21mm of usable shaft (the portion which does not have threads at the end).
Adam S.
2025-07-25 18:01:34
The product came with severed wires, but I had some solder and heat shrink so it wasn’t too big of an issue, the motor is working great so far.
Robin
2025-06-15 16:29:50
Bought this replacement for my son razor moped scooter, works great!!!
BC-Atlanta
2025-05-01 16:19:52
I was not able to tell anything about the motor because when it arrived and we took it out is the box a wire snapped off as if it was worn. Returned the motor.
Rebekah M. Green
2025-04-27 15:43:33
The media could not be loaded.
Pyzik
2025-04-01 11:48:01
It was a plug and play install. And the motor worked perfectly.Only returned because turns out the motor wasn't the issue.
Laura R.
2025-03-09 16:09:08
Lo utilize para hacer un patin eléctrico para un proyecto y funciono a la perfeccion, muy buena potencia y el piñón de cadena que ya viene incluido fue muy util
DRE
2025-02-13 11:39:48
Operates quietly. A replacement 1/2 " pitch sprocket is available on Amazon. Original sprocket comes off easily after remembering it is a left hand thread!New sprocket is a 410 type (only 1/8 " wide), and not so useful. I bought a second one and installed them back to back, creating a 40,41,420 compatible width. See pictures.
Aaron Henderson
2025-01-21 09:16:49
Converted my 2010 Trek 3700 to an pedal assist ebike with this motor. I thought I would try the 250W first I am only 120lbs, and the mid-drive setup allows me to change gears...and it seems to be working very well so far! Super quiet, only noise is really the extra chain. I had to get a different sprocket, 410 sprocket or something, to run a bike chain, but that was on Amazon for $10. I use it with an inexpensive LB27 controller and just a small 24V 7ah battery right now. Now that I know everything works, I will be upgrading the battery. Total cost of conversion, with the small battery, was about $160...very happy with that! I have a permanent leg injury and this makes it barely noticable when biking now! I am now thinking of other projects that could benefit from this motor!
Gordon A Storey
2025-01-08 13:46:43
This motor performed exactly as I needed. Running a small air compressor cylinder.
m. leroux
2024-12-12 17:44:56
fonctionne comme prevus