Your cart is empty.
Your cart is empty.Add a thumbnail edge to your drawer and cabinet Door fronts using this Yonico 12161 edging router bit. 1/2" Shank.
C. J.
2025-09-02 13:22:45
Ordered it, it got here quick, used it for the job at hand, excellent results, job done. I have bought other bits of this brand (and still using them) multiple times in the past, will be buying more as needed. Good quality, reasonable cost....... Hay........what more can I say? CJ 5/2022
Zaltana
2025-09-01 17:21:42
Doing Oak draw fronts. Smooth finish and no burning.
James C.
2025-08-28 16:57:38
The bit was satisfactory, not the best quality steel so the cut needed sanding. However for the price I would say it is worth every penny.
Stanley
2025-08-10 12:43:38
Leaves a nice clean cut . I had to create my own base plate for my trim router to use this bit.
Daniel L. Gagner
2025-07-29 18:49:27
I first ordered a Yonico router bit a few years ago. I've got lots of Freud's and CMT's. I only needed the bit for a one time use profile so I figured I should be able to get at least one pass out of it as it's so inexpensive. Well, I was surprised at it's quality (it was a beading bit), and have since ordered a few more. They seem to be as good quality as the expensive brands. Shouldn't be but gee... I'm getting mileage out of them. The carbide lasts and the finish is like a good quality one. Often with cheap bits the paint job will be bubbled and pitted. The paint doesn't really matter but it makes the product look 'better' quality. For bits that I use once and awhile they are fine. I think they'd be fine for more long term use too. It's nice to get a decent quality tool at what should be a premium price. recommended by me for any other woodworkers out there.
Customer
2025-07-17 14:20:03
i liked the quality of the product , works pretty well.
Vespasian
2025-06-30 16:02:52
For the money they are decent. I have bought about 15 different profiles for various jobs in my cabinet shop. I usually buy them in pairs because the carbide isn't as good as what is put on the Italian bits so they do wear quicker on hard woods with a high mineral content like some Maple can have. You'll get some friction burn when they dull so if you have a decent amount of lineal feet to do, buy 2. 2 are still cheaper than 1 Italian made. Chipping is also an occasional issue but then again, they are inexpensive. I will say this though, Yonico does have a good selection of hard to find previously popular profiles so sometimes this is your only choice without going custom if you need to match something. As long as they stay reasonably priced, I'll keep buying them but if the price jumps and the carbide quality doesn't improve, I go back to sourcing European and American produced bits that last longer.
Raymond Braun
2025-06-26 16:18:39
Liked did as advertised , cut clean and smooth.
L G Cruz
2025-05-29 12:37:52
De muy buena calidad, hice una prueba y funcionó a la perfección. Lo recomiendo al 100%.
kemo kemolino
2025-05-25 11:05:26
Value for money I would recommend
TF
2025-05-12 14:46:44
Shipping was quick bit worked really well too!
Gilbert
2025-04-10 12:12:44
Nice bit but exactly as shown in picture. Shoulder not exactly the same as picture in description.
James Brough
2025-01-29 19:27:56
Arrived on time. Good bits.
Recommended Products
$109.99
$ 44 .99 $44.99
$42.95
$ 19 .99 $19.99