Your cart is empty.
Your cart is empty.
Features:
Circuit breaker stops surges from damaging your amps.
Unique red push button reset manually.
Panel mount and protective stud insulators included.
Easy to install, Manual Reset Circuit Breaker, Mount on panel or firewall.
Water resistant housing. Splash and dust proof.
Typically used in DC systems in marine applications (as a main or branch circuit breaker), truck, bus and RV systems, add-on protection for accessories.
Specifications:
Material: Metal and plastic
Mounting: Panel Mount
Main Color: Black
Rated Current: 50A
Voltage: 32V DC
Waterproof Rate: IP67
Reset Type: Type III, Manual Reset
Termination: #10-32 threaded studs
SAE Standard: SAEJ553 SAEJ1171
Interrupt Capacity: 2500A @ 14Vdc
Operating Temperature: -32°C to 82 °C(-25°F to 180 °F)
Wire Connection: BAT LINE SHI for input wire, AUX LOAD for output wire
Package included:
1 x 50 Amps Circuit Breaker 12V-32V
Customer
2025-08-18 14:03:58
Good product. Worked as described.Well made.
LUIZ DIAZ JR
2025-06-02 10:16:37
I purchased and installed Installed this on my boat for a Ace Brut line hauler. This replaced a 30 amp fuse that blew too fast. I've only used this circuit once for a lobster hooping trip and this held up well, no trips. Once finished with my fishing trip, it can be tripped to to de-energize the circuit. I would buy again if the need arises.
C MC
2025-05-30 10:02:36
Works fine.
Mitch Martin
2025-05-26 11:59:55
This is a nice, small, waterproof breaker for the price. It comes with a decent rubber gasket that sandwiches between the mounting spot and the breaker itself. It doesn't include the mounting bolts, so you'll have to source them yourself (should take a #10 if I remember correctly). The terminal size is #10-32 threaded studs.If you reference the provided graph, the trip time on this 10A breaker can be as much as 10 seconds at 200% capacity. So at 20A with a 10A breaker, it could take 10 seconds for it to trip. This is what I was seeing with this hooked up and testing some load conditions. A faster trip time would be ideal, so just make sure the equipment/cabling downstream of the breaker can handle temporary elevated current levels.Overall, the breaker is small and waterproof. Easy to reset by the flip of the yellow lever. Would recommend.
Gilles
2025-04-10 13:43:09
So far so good! a third of the price of the OEM, so it can fail 3 times before I loose money...
t
2025-03-23 15:49:40
Used this for solar panel isolation from MPPT charge. Install was easy. Using heavier guage wires and was a little difficult to get the wire around the nut. Not 100% sure on size, but I'd guess 8 gauge. Also, there are nuts in the screw holes. I tried to punch them out and couldn't get them to budge. I ended up finding a smaller screw to go through the hole into the wood I was securing the breaker and wiring for the charger. Overall it is what I needed, but the sizing was a little small for wiring I had and I don't have any idea why there is a nut built into it (and it doesn't come with screws).
Jon Lazzarini
2025-01-17 21:03:52
I installed it on my boat and the first time it tripped (after about a month) the lever to reset broke off and now it’s useless
Handy Dandy
2025-01-07 18:41:10
I like these circuit breakers. I put them on my Tacoma for an dual on board air compressor. It required one per pump. I put these under the hood and the pump in the rear bedside compartment with a on off switch at the bed. Everything is ignition controlled. These were a reasonable price and seem like decent quality. I would recommend and I will be buying more in the future for other projects.
Recommended Products
