Your cart is empty.
Your cart is empty.Product Description
Basic parameters:
Size:80x230mm (Middle body diameter:80mm; Length:230mm)
Cooling:Water cooling
Power Interface:Optional H20-4 pins waterproof air plug. The air plug marked "1 ","2"," 3"," 4", "1 ","2 ","3" were connected to inverter (U, V, W), 4 connected inverter ground.
Power: 2.2kw
Voltage: 220v
Current: 10A
Frequency: 0-400Hz
Speed: 0-24000rpm
Diameter(mm): 80
Bearing Type: 2 x 7005 P4 DT & 2 x 7002 P4 DT
4pcs 7 Series Fully Sealed Angular Contact Bearings
Collet: ER20
Water Cooling ER20 collet chunk
Grease Lubrication
We are the spindle manufacturer,we use better material to produce the spindle.
1.We use steel bearings seat,spindle will not morph during the using life.Increase the spindle using life.
2.We use 4 pcs 7 series fully sealed angular contact ball bearings, it quality much better, usually use it 1-2 years without any problems.
3. Full power spindle, stronger shaft and coil,more power in engraving and cutting working.
4. Precision 0.01mm.Coaxial degree less than 0.0025mm,suitable for high accuracy work.
5. Carefull assembly make the spindle more precisional. 3-4 hours testing after assemble, 99.9% pass rate. No worry after ordering.
6. We work with biggest CNC router manufacturer in USA, EU,RU. Strong work partners.
Basic parameter
Power: 2.2KW
Input voltage: 220v
Output Current: 11A
Input phase: 1 or 3phase
Input frequency: 50-60Hz
Output phase: 3phase
Output frequency: 0-1000Hz
Control method: V/F Control
Basic parameter
Diameter: 80mm
Material: Cast Aluminium
Basic parameter
Max Head: 3.2 m;
Power: 75w;
Maximum flow: 3200L / H
Plug Cord Length: 1.4m
Voltage: 220V;
Frequency: 50 HZ
Outlet size: 4 and 6 mm;
Dimensions: 145 * 110 * 90 mm
Basic parameter
Type: ER20 High accuracy collet Material: 65Mn Steel
Quantity: 8 pcs (4mm,6mm,8mm,10mm,12mm,1/4(6.35mm),1/8(3.175mm),1/2(12.7mm)) Precision ≤ 0.008mm
If the spindle will not be used for a long time, please keep the spindle oil sealed to prevent rust from being unused for a long time. Before shipping , we did the oil seal to avoid the rust during the long shipment. When you get the spindle, please clearing the oil seal before using. Thank you.
Water cooled spindle MUST be used with water pump. Otherwise the spindle will soon broken.
AC spindle motor MUST use with inverter. The power of inverter need equal or bigger than the spindle power. Before using,please set up the inverter parameters suitable for spindle. Otherwise the spindle and inverter will broken at once.
When you use the spindle,the noise is not same as always,please STOP the spindle at once. You may need to replace the spindle bearings.