Your cart is empty.
Your cart is empty.Description: Table diameter 80 mm (3") Table is graduated 360 Degrees. Worm Gear Ratio -1:36, which means that the 1 handle rotation shall turn the table by 10 Degrees. Center Height in vertical position without chuck: 2-5/8" (66 mm approx) Hand wheel is graduated in divisions of 10 min & can be set to zero. Can be mounted both in Horizontal & vertical position Supplied with a 65 mm 3 jaw self centering Chuck + Back Plate + T nuts for quick clamping
Jim Patchell
2025-08-29 16:27:14
For what it is, it is really good. It sure seems like it is very well made. Everything is nice and "tight". When I turn the crank, it feels very smooth. I know there must be some backlash in it, somewhere, but holding onto the rotating table while cranking it back and forth, I was not able to feel any. The surfaces that are mated with the top of the mill table are very smooth and flat. I am using this tool on an old Enco Mill/Drill, so I am sort of using it on a machine a bit bigger than what was probably intended, but so far, no problems. And it was very easy to fit the chuck onto the table. Only took a few minutes, and like everything else, no slop to speak of, in fact, at first I did not think the back plate was going to fit in the spot for it on the table, but it does just slip in. And the keyless chuck also works very smoothly.
CFitz
2025-08-23 10:34:05
Good for the price, after cleaning still has some rough areas while loosening or tightening. But for the price it will get the job done. DHL shipping was very poor, sat in Denver for 3 days before continuing to final destination.
Customer
2025-08-08 16:39:29
I am very pleased withe the fit and quality of this small positioner, there is no wobble or misalignment everything is very tight, rotates easy but not sluppy. Nice for small welding projects. Can be easily mounted vertical or horizontal. And if u remove a small allen screw u can attach a 3/8" drill to the center post to power the rotation.
Rick Wiman
2025-07-10 14:40:23
I had to take apart the chuck. The 3 clamp slide pieces did not slide well in the slot. I had to grind and sand them down. The hole that the clamp goes into need to get ground out a little bit too because that hole needed to be opened up a little bit to receive the clamp. It only took about an hour and a half with proper tools to fine-tune it.
Glenda Walker
2025-04-15 10:19:40
As advertised
JRC
2025-02-22 11:00:04
Used this to build a weld positioner. After cleaning up the casting slag internal to the gears, this thing works well for my project.
Brian Boykin
2025-02-15 15:40:16
As advertised and is well built. Packaged very well and delivered promptly.
Sterling
2025-02-14 10:51:00
Jaws are not square and will need to be re ground to be used, operation isn't smooth and it will need to be cleaned up.
Recommended Products
$25.49
$ 11 .99 $11.99
$26.50
$ 12 .99 $12.99