Your cart is empty.
Your cart is empty.Material: SteelFinish: Zinc PlatedOverall Size: 4-7/8"Cutout Size: 3/4" Wide X 2-3/4" TallLarge Hole For Use With Mortise LocksComes With Screws
Todd Stites
2025-09-04 11:39:22
Perfect for what I needed. We have an apartment that “shifts†depending on the season. During the winter months our bathroom door doesn’t latch. I removed the old plate and installed this one with the larger opening without even needing to cut into the door frame.
DelKar
2025-08-10 14:36:38
Solid piece, the original broke off and I selected this one. Used my dewalt oscillator to cut the recess and fit this in. It’s very solid and the door closes properly now.
gigo
2025-07-05 10:23:19
Very precise for what I need it.
hugo balder
2025-06-17 16:26:51
Had to cut of the "lip" for my application. Deadbolt in a garden gate. The long version gave me enough room for the deadbolt over the time of the year when the gate moves because of humidity changes (Louisiana). Also it was helpful that the screw holes are far apart so I could screw it into place in an area that wasn't affected by former installs. Metal is thicker then the stuff I have seen around in stores.
Kindle Customer
2025-05-05 18:49:01
The metal seems sufficiently strong for residential use, and installation was straight-forward. It will certainly help the front door on my mobile home which tends to rise or fall based on the season and amount of rainfall. The extra long slot allows about 1" total vertical movement of the door so that the lockset and dead bolt still align with the strike plate. This should address any foreseeable vertical movement.However, I found the slot was too narrow for the dead bolt, and barely wide enough for door latch bolt. My solution was to remove the narrow portion, opposite the the curved portion of the latch plate. I don't think I compromised the strength of the plate by this adjustment, but it did add another task to the installation. I also used 2" screws to provide additional security of the strike plates to door frame.
Maddie
2025-04-05 13:35:51
This makes it easier for lock to go in the hole!
Ghendorf
2025-02-26 13:19:19
The hole is definitely good sized and fits my deadbolt perfectly. I needed this since shifting has caused the old one not to fit or allow it to close anymore. With this I can now give the shifting plenty of room.The screw holes are tapered unlike another striker I bought allowing the screws to fit flush and snug.It's made of good quality and does an excellent job.I would recommend and buy again.
McCain
2025-02-09 17:52:03
Things are strong, easy to put cones with screws extra tough
Recommended Products
