Your cart is empty.
Your cart is empty.Create extra tight connections for 2C white or single color LED strip light with Armacost Lighting's 2-Pin tape to wire LED screw connectors. Simply insert wire and tape into the connector, then tighten screws to lock into place. Use this unique strip light connector to reconnect cut lengths of tape light or to connect your installation to a remotely located driver.
TROY GRIFFIN
2025-06-24 09:48:31
Worked great! Also works with COB (continuous) LED tape light. Just be careful, the screws are easy to lose!
Sasquatch
2025-06-16 14:52:47
Worthless - the screws are nearly impossible to turn and they don't make a solid connection resulting in very dim if any light downstream.I am outside of the return window but would like my money back for these.
olyone
2025-04-14 16:29:44
worked great
CC
2025-03-13 10:26:18
I used these connectors with the Armacost RibbonFlex Pro 24-Volt White COB LED Strip Light Tape 4000K 16 ft. I tried several other connectors with these particular lights and these connectors worked best. There is a catch, the tape light must be cut at a solder point for a good connection. Solder point is located every 20 inches on the lights I used. If you cut at any other cut point, then solder would need to be added to make a good connection.
Kindle Customer
2025-02-16 20:29:19
The product is excellent but the item that sets this company apart from the others is their customer support. They have a phone number that they actually answer. If they can't, they get back to you within 24 hrs! Their tech support is top notch. I explained what I was trying to do and they gave me a list of part numbers and quantities. They were winderful!
Customer
2025-01-21 13:52:40
Only two of the six worked and I had to crank down hard on the screws to even make the connection. I know it’s the connectors because the ribbons light up when touched directly with the wires.
J. E. Tomczyk
2025-01-05 14:51:12
After trying to get a good connection by following the pictorial instructions ( I tightened the LED screws so much the metal contacts started to twist ) I modified the wires by twisting and soldering them, then flattening them with pliers. Similarly I added solder to the round pads on the LED Tape connections, then wiped the tip of the iron off and used it to wipe solder off the pads till they were only lightly covered. These mods made the screw connections much firmer and more positive.
kr212
2024-12-31 09:02:49
These worked quickly and easily to avoid soldering. Used 4 in one circuit and still conducted great. Even had to redo 2 and still worked.
Recommended Products
