Your cart is empty.
Your cart is empty.Mini grease gun with needle nozzle. Grease gun.
Peter
September 1, 2025
I have been using the "other" types of bar greasers for decades and they were fine. BUT this grease gun is far, far, far superior to "those".Why? It has a lot more power and makes greasing the nose super easy. One easy-to-apply thumb pump and you are done. PLUS, you can fill it with grease for a BUCK+- and use the grease YOU want to use. In my case, I have 30 gallon barrels of grease and the fill cost is almost pennies.This grease gun works amazingly good. Highly Recommended.
Steven P. Spinella
August 20, 2025
First I bought a tube of bike lube (Finish Line) with ptfe (e.g. teflon). It works, is easy to squeeze, and a bit messy. But a 16 oz jar of grease and this grease gun is a much better deal and a more lasting solution. I'll still take the 2 oz tube of bike lube when I travel with a disassembled bike. (Whatever happened to 35mm film canisters?!)My grease gun arrived with a perfectly fine pinpoint hole in the nozzle, ready to go.True, the instructions are on the side of the grease gun. 1) I unscrewed the top. 2) I used a piece of plastic coated cardboard from my trash can as a paddle (cut to just fit inside the tube,) and started paddling in my grease. (True, the picture shows a finger.) 3a) Once I had crammed in as much grease as I could easily fit, I put the lid on firmly, shoved the disk inside the bottom toward the top with a screwdriver, and then took the lid back off. (True, this was an extra step not pictured on the can.) 3b) Now I took the cartridge and sharply hit the bottom of it downward onto my other hand. What do you know, the grease slid in, allowing me to again fill the cartridge. (True, the pictures don't show filling the cartridge more after the tapping.) Filling it twice was good enough. 4) I screwed the top on tightly (by hand firmly) so the grease wouldn't leak through the threads, pressed up again through the hole in the bottom with the screwdriver, more firmly this time. (True, the instructions show the cap on, while the previous picture shows it off.) 5) I began to pump the spring-loaded plunger (with the tip pointed toward my open can of grease.) A satisfying, but highly controlled thread of grease emerged from the pinpoint tip. (True, there is no fifth picture on the can.)I'm actually using Finish Line Ceramic Grease, which has both ceramic and fluoropolymer (ptfe, teflon, etc) additives. A 16 oz tub ends up cheaper than multiple tubes of grease, even including this grease gun.But still, a ziploc baggy with a hole cut in the corner, and automotive grease would be cheaper, so this is more or less a little luxury for a guy who buys his fancy bikes off Craigslist.... To each his own!
Luis Aguirre
August 1, 2025
Bought this to grease my Mid-Rise Scissor Lift as it has like 30 if these fittings on it. Works as it should, 5/5
Richard
June 27, 2025
A good little mini grease gun that works fine now that the tip is drilled out. (yes the top is blue because I painted it to tell it apart from others on the workbench). After I filled it with Park Bicycle Grease using an old spoon, I could not get any grease out, no matter how hard I tried. Finally looked at the tip and the hole, if there even was a hole, was too small to let any grease out. The smallest bit I have is 1/16" so I drilled the tip out with it. Just took a few seconds, and now it works just fine. If I had had a smaller wire guage bit I would have used it, but 1/16" is fine and lays a nice bead of grease. Should come from the manufacturer with a better tip.
James Badger
June 10, 2025
This little guy has been indispensable since I got it. Prior to getting this grease gun, I just used my fingers like my father before me, but I watch a lot of videos in which pro bike mechanics use grease guns like this, and it looked so much simpler, especially when packing grease in headsets and bottom brackets, which can get really messy if you just use your fingers. With this gun, it's easy to control where the grease goes and how much of it gets used. If you work on bikes regularly, you really ought to have one of these. Honestly, I might start keeping mine in a holster.
Jeff F.
May 31, 2025
This thing is great, I love it. The build quality is much better than expected and is a nice heavy little tool.It's a great value and seems to be identical to the park tools version that costs much more.The tip is perfect for getting grease into places on a bike like the headset races and bb, etc. It puts out a thin perfect line and makes applying grease so much easier and really satisfying lol. I would say the line of grease the nozzle it comes with puts out is about 1.5 or 2mm wide just eying it up.The pump works great and always get a consistent amount of grease with just a few pushes of the thumb. I use a tube of Maxima grease and spoon it into this. Then you take a screwdriver or Allen key or something and push the plunger up from the hole in the bottom to prime it before using it and then it just works. I need to find an easier way to load it up with grease from my tub of it than a spoon lol but so far the method has worked.
Jay K
May 9, 2025
Applying grease precisely and accurately to locations can some times be a hassle and often ends in greasy fingers. No more with this little grease gun! Greasing chains, seals, bearings, whatever; having a fine applicator with a nice volume of grease on hand makes doing the rounds on all your tools fun and easy to do.While I’ve use similar ones that screw onto the top of tubes, having the ability to pack my own grease into this one is very nice.I always enjoy when I have an excuse to use this and expect it will continue to work well for years to come!
Customer
April 18, 2025
no issues with product works great
WWR
April 2, 2025
This works well. Make certain that you put the grease in carefully. Most important, bleed the tube before using.
Adrian Teo
February 11, 2025
when filing up for the first time, push the metal bottom plate up until it's almost at the top. Leave a small volume available and then fill in the grease. As you add more grease, the bottom plate will move back down. It's less messy this way. Thanks to another reviewer who suggested this. For ease of filing, I used an old butter knife.Crazily enough, I had to use a sharp pin / panel nail to burst the sprout open. It was completely sealed.Once that's out of the way, works like a charm. Well made basic grease gun for my bike repairs.
Paul
February 10, 2025
Habe sie zuerst von Hazet (selbes Produkt, nur anderen Namen eingelasert) gekauft und dann nochmal diese hier. Dabei dachte ich zuerst, dass das eher ein Fall für „hat man mal, falls man es braucht“ wird. Das auffüllen war etwas schwierig ohne fettpresse, ich habe mir dafür einen Stopfen gedruckt.Ansonsten ist es einfach super. Man hat immer schnell etwas zum fetten griffbereit, was sogar einhändig bedienbar ist. Sei es ne Mopedachse, die Welle eines 3D-Druckers oder türscharniere. Fein dosierbar ist es auch, ich habe sie tatsächlich noch nie für schniernippel eingesetzt.
Bowers
January 29, 2025
Very good little product. Great for precision things.
Jens Vegeby
January 19, 2025
Använder den till EP2-fett, till bland annat linjärlager. Så mycket bättre än att använda spruta och kanyl!
Recommended Products
