Shopping Cart

Your cart is empty.

Your cart is empty.

Criditpid F299201 Vent-Free Blower Fan Kit for Mr. Heater, 20,000-30,000 BTU Vent-Free Heaters (2016-present), Replacement Vent Free Wall Heater Fan Blower Accessory Kit for Mr. Heater.

Free shipping on orders over $29.99

$25.97

$ 12 .99 $12.99

In Stock

About this item

  • ➤【Compatibility】--- F299201 Blower Fan Compatible with Mr. Heater 20,000-30,000 BTU Vent-Free Heaters for models 2016 to present. Fits NTE Item#s 52563, 52564, 52569, 52570, 52558, 52559, 52561, 52562, 255839 and 255639. F299201 Blower Fan are only utilized with 20,000 – 30,000 BTU units. It does apply to both radiant and blue flame models of either propane or natural gas. ★Please Note: This blower fan does not apply to 10,000 BTU, older 20,000 BTU model, older 30,000 BTU model.
  • ➤【Specifications of The F299201 Blower Fan】--- ★ The dimensions of this Mr. Heater blower fan is approx. 5 3/8'' x 5 3/16'' x 6 1/8''. The spacing of screw holes is approx. 4 7/8'' x 5 1/2''. Power Cord Length: 54". ★ Volts: 120V, Airflow in C.F.M: 18.5, Power Consumption: 18w. Amperage: 0.02AMP. Heating Product Type: Vent Free. ★ All Components UL Listed.
  • ➤【AUTO/OFF/Manual Operation Mode】--- Installed switch installed on the blower is a three-position switch. Set the switch to 'MAN' for manual mode, allowing the fan to continuously run until the switch is returned to the OFF 'O' position'; Set the switch to 'AUTO' for the automatic mode, which will automatically cycle the blower on as the heater heats up and then off when the unit has cooled.
  • ➤【Ultra Quiet Operation】--- The aftermarket ventless heater blower fan kit features a Ultra Quiet, which runs very smoothly and is very quiet while moving a lot of air. Heats your room quickly, keep you away from the cold and noisy winter!
  • ➤【Easy to Install】--- The F299201 heater fan is complete assembly, includes power cord, built in thermostat, mounting screws. Only a screwdriver needed, expert installation not required. Mounts to back of heater. Can be used on wall heaters that are wall mounted or floor mounted.


F299201 Blower Fan Kit for Mr. Heater 20,000-30,000 BTU Vent-Free Heaters (2016 to Present), F299201 Vent-Free Blower Fan Accessory Kit Replacement Parts.


Specifications

★ Dimensions of Fan: 5 3/8'' x 5 3/16'' x 6 1/8''

★ The spacing of screw holes: 4 7/8'' x 5 1/2''

★ Volts: 120V

★ Airflow in C.F.M: 18.5

★ Power Consumption: 18W

Compatibility:

➤ Fits for Mr. Heater 20,000-30,000 BTU Vent-Free Heaters space heater from 2016 to current models.

➤ Fits NTE Item#s 52563, 52564, 52569, 52570, 52558, 52559, 52561, 52562, 255839 and 255639.


【Advantage & Benefit】

👉 High Quality Blower Fan

👉 UL Certified

👉 Powerful, Quiet, Energy Efficient and Long Lasting.

👉 1 year warranty


Note: Please double check the size of your original parts, and compare with ours to ensure proper fitment before ordering.




DT
August 14, 2025
These work great this far. I installed two of these into my heaters and they really install nicely and make quite a difference!
CAMERON ROBERTS
August 3, 2025
The media could not be loaded.
Bazza.
July 21, 2025
Blower for a propane heater. Noise not to bad , easy to install although directions for where thermostat fits could be clearer. As could the picture of the fitting.
Cara G.
May 27, 2025
Fan is loud and the auto function has already stopped working
Chris Slone
March 12, 2025
This fan works good. The first one sent worked but when on auto it keep kicking off and on like power surging. But the replacement one works great. Thank u Amazon for the replacement
Customer
March 3, 2025
Easy-to-install
Kyle Hill II
January 22, 2025
I like that it was the exact fit for our heater. Easy to install. Great bang for your buck. Thank you, Kyle Hill II
James M. Kitchen
January 8, 2025
This fan is noisy and dont have alot of wind power ! Pain to break out the cut out to install on MR Heater ! Dont Buy THIS !!!! Instead buy a HEAT POWERED FAN INSTEAD !!! Buy the CWLAKON WOOD STOVE HEAT POWERED FAN and put on top horizontal wire shield ,secure the bottom with some bare ground wire and you will be so much happier !!!!!!!!
Recommended Products