Your cart is empty.
Your cart is empty.Product Description
Teri
July 8, 2025
We bought this to improve heat flow on our propane fireplace. It works perfectly! Low volume, adjustable speed. Warms our entire great room! A definite 5 star product. The instructions, not so much. Use a YouTube video to set it up.
Jdavid thompson
July 5, 2025
Bought a home with a built in “just for looks†natural gas fireplace. Soon realized it main benefit was to increase NV Energy’s bottom line, not heat the family room. After a little investigation, realized it was compatible with the Criditpit thermostat blower kit. Installed in 1&1/2 hours and worked great from the start. Blower has an adjustable speed fan, thermostat turns on blower when the fireplace heats up and turns it off fireplace after fireplace is turned off and cools down. More than met our expectations.
Drew
May 15, 2025
At a fraction of the price of the oem replacement I was skeptical about its quality. But so far there has been zero issues and it blows very well
Michael
May 14, 2025
Very easy to convert to fit to my gas fireplace!
Dave Goodman
April 9, 2025
Overall good value. I looked at others and this has a good quality fan at a very reasonable price. The installation could have been so much easier if the leads to/from the temperature senor were longer. They were way too short to connect the sensor to the fan and the sensor to the variable speed on/off switch. What a pain. Also the two wires to/from the sensor are not rated for high temperature. So you have to keep them from getting near the fire box. Remember, you have 120 volts running through those wires. Failure of these wires will cause an electrical short.The sensor needs to be mounted near the top of the fire box. Therefore the wires to/from the sensor have to reach the fan, which will sit in the bottom back side, and the other wire connected to the front fan speed controller. I had to replace the provided wires with longer wires. The provided wires were about 18" and you will need close to 36 inches. I installed new wire and wire connectors (insulated type wire connectors). And of course, the wire connectors used must likely will not mate with the new replacement connectors, as in my case. So other connectors had to also be replaced as well. And you will need wire crimpers for insulated connectors. Some twist ties or equivalent (zip ties) may be needed to make sure the wires stay neat and away from the hot fire box.The fan speed control switch goes from off to low speed and increases as you turn the knob clockwise. This was opposite to the fireplace label that was on the existing control panel. No big deal as this is covered by the grill, just something to note.The fan is nice and quiet and does what it is suppose to do. This is located in our TV room and I did not want a noisy fan running while watching TV. I run it at the lower speed as to reduce the noise level.
Customer
March 25, 2025
you can adjust the blower speed , on hi it's a little loud. but pushes the hot. air out of. the fireplace. Once the temp reaches the temp. the fan will start up automatically and once the the fire is off. will auto shut off.
Herby
March 22, 2025
A little more difficult to install since sensor is attached with screws.
Brad Franke
February 14, 2025
Love this blower and system. Got our ventless gas fireplace up and running again perfectly Very fair price for a great item. Have had it running nearly non stop for the past month.
James
November 30, 2024
It's quiet on low level, but you need to run it on high to blow out a good flow of air.
Recommended Products