Your cart is empty.
Your cart is empty.Product Description
Dokili 36mm x 32mm Fan Clutch Nut Wrench, 2 Pieces Fan Clutch Wrench Set, Water Pump Holder Removal Tool Fits for BMW
Superior Material
- Adopted almost the toughest tool steel material on the market, each one is further galvanized to resist wear, tear, and corrosion under even punishing use.
Dokili Fan Clutch Nut Wrench
- Features - Dokili Fan Clutch Wrench Set makes it easy to hold water pump pulleys in place while you loosen and service your radiator fan.
- Function - For removing water pump on models with temperature dependent viscosity drive fans.
The size shows in the picture.
The wrench is covered with rubber process, which is different from the wrenches on the market in feel, more comfortable and non-slip in hand.
Fan Clutch Holder fits for BMW engine models : M10,M20 ,M30,M40, M44,M50,M52,M52TU,M54,M56,M60, M70,M73, S14, S38, S50B30, S50B32, S54
Douglas Case
September 6, 2025
I tried to remove the fan from a 2002 trailblazer. Rented tool from Auto store and it didn't work. Got this the next day and popped right off. Great deal good quality.
Steve E.
September 1, 2025
Worked out great for changing the fan clutch on an 04 trailblazer ext.
Flo
August 24, 2025
Pretty good, does the job
John Fulp
April 22, 2025
Was well make for how thin they have to be to get into the spot they have to be used. I used on an 08 ford explorer will also work for most of the earlier ford v6 and v8s.
robert
April 20, 2025
If i had it to do over I would use a straight 36mm not offset. For set difficultly tight fan clutch nuts this is a little light duty. the rubber cooating seems nice but makes it to where it is difficult to use a hammer for impact blows to loosen. Nice quality unless the fan is really tight. Ends are off set which made it hard to use vs a straight wrench
Wes Mayes
April 17, 2025
Great tools, worth the money.
Mr. Fantastic mr. Bombastic!
March 5, 2025
it does what it was made for, nothing more, nothing less
F
February 22, 2025
Extremely soft stamped steel. It's magnetic, so it must be steel, but it definitely feels like cheese.Wrench expanded from 36mm (didn't measure it) to 36.8 on the inner part, 38.2 on the outer part. It slipped off the nut and didn't round off the aluminum nut.Fan clutch pulley holder did not end up fitting on the AJ133 engine. I put it on one screw, and it's now bent like an unhappy banana.
ronald c.
February 6, 2025
It's not like a real wrench that is thicker, just spins on a nut. So I bought a 36 mm Wrench. The holder for the pully works great I bought 2 different types clutch wrench did not work I would send it back don't know how much it cost me
Recommended Products