Your cart is empty.
Your cart is empty.Restore the ease and convenience of a properly functioning vehicle door with Dorman's Door Hinge Pin and Bushing Kit. It returns a sagging door to proper alignment and operation while saving you time, money and labor. Dorman's Door Hinge Pins and Door Hinge Bushings are also available separately.
Jason
August 26, 2025
Exactly what I needed. Not sure what peeps are saying about bearings. These fit in the hinge tightly just like wheel studs in a hub.
B. Delien
August 7, 2025
These were a nice purchase for my Jeep.Installed perfectly, fit nice, and are much stronger than I anticipated. Definitely recommended !!
Laurie A York
July 11, 2025
Got these for a 2004 jeep wrangler and fit great.
Huh
July 10, 2025
These were a perfect replacement for my 2001 TJ. I had no issue installing them. They were quite nice. I also made sure to put some silicone grease on them to prevent corrosion. I don’t think these are coated but if they are, I had extra insurance.
warren jenkins
June 26, 2025
Worked perfect easy to install
Mark
June 20, 2025
The splinds fit perfect, just like factory.
Cub
June 7, 2025
These are ever so slightly smaller in diameter than the factory Jeep door pins on my 2003 Wrangler Rubicon doors. However, these work perfectly fine. Use an air hammer or you will be sorry! An air hammer makes it easy to bump them out without swinging a hammer towards your doors. For those of you wondering, the nuts on the end of these pins is the same size as your factory door nuts! Also, as others have said, this kit is two pins, two nuts, no bushings.Again there are no bushings with this kit. What you see is what you get.
Bob kurz
May 26, 2025
My 2005 Jeep Wrangler Drivers door was hard to close. I installed the plastic inserts for the pins several months ago and things were better. This week I put these new pins in and the door operates almost like new. I need to get the "junk" out of the door pocket to quiet things down a little more. This is an easy job!! I didn't even remove the door. I used a lot of masking tape to protect the paint because I hammered out the old pins. Door closes great now!!!Tape, a 4 pound hammer, 13 mm box end wrench and, 3-in-1 oil is all you need.
phil scott
April 19, 2025
Fits like original ...
Frank
April 11, 2025
Font parfaitement et facile de les installer.
calvinator
March 26, 2025
I would have liked to see them add in two washers, because there is a small gap between the nuts on the pins thread and the door hinge. I may just use my trusty Tap & Dye set to make the threads longer so the nut goes up the pin/bolt further, thus eliminating the gap between the hinge and nut.
Steve Barclay
February 3, 2025
These are not a suitable replacement for Jeep door pins. They appear to be cheap metal. The first time installing them, when I went to tighten the bolt down on them, the threaded section sheared off.
Sheldon Schroeder
January 31, 2025
I purchased them as a door and bushing kit as advertised . They don’t come with bushings. I had to order them separate so double the freight to Canada.
Recommended Products
