Your cart is empty.
Your cart is empty.Simplify your plumbing and home improvement projects with the Eastman water heater connector. This water flex hose features deep corrugations of stainless steel that provide long-lasting structural support against crushing, kinking, and cracking. This 18-inch water heater connector is built to last and withstand corrosion. The end connections provide a safe and solid bond that will prevent any disconnects and leaks for many seasons. This water heater hose is equipped with 1 inch FIP x 1 inch FIP connection and features brass end connections with nickel-plated brass nuts for a tight connection. This water connector is designed with a working pressure of 125 PSI with an intermittent impulse pressure of 180 PSI, a working temperature range of 40 degrees F to 180 degrees F, and an EPDM washer gasket. Eastman water connectors are Lead-Free compliant for safe water drinking and are UPC approved.
Edward
2025-07-29 10:46:54
Great strong hose. 15 inch was perfect for my needs. no leaks. Hooked it up from my well tank to the filter. 1 inch both ends.
The Reel Deal
2025-06-13 13:46:24
Having come across an insane angle I needed to traverse, this was perfect. I'm using both SCH40 & SCH80 with this & it is perfect. Tightens down easily (there is just enough for the tip to spin while the shaft does not move) and not a drop leaking using both paste & tape on connections.Be SURE the gasket is in the unit and the gasket MUST be the one they provide, if it's not there, don't try and put anything but one matching the dimensions of what they provide, or ask for one from the company (lesson learned by me).It is tough to bend, but that turned out to be great since it reduces vibration during fluid flow and thus, puts considerably less stress on connections. Used one for a temporary straight through and, even with several millimeters of "jolt" as the pressure increases 80PSI for well loads, not a drop after over a month.Super light, easy to use and really does a great job if installed properly. I'll try and update with a photo later, let's give it a few months and check back in then :-)
Ken Stromberg
2025-06-03 13:51:30
Although a 12" hose doesn't allow for too much flexibility this hose gave us just enough to allow us to install our new water pump. It replaced a prefitted hose from the old pump that just wouldn't let us mount the new pump where we need it to be. Made the new installation quick and easy, would definitely buy this again!
J. weatherly
2025-04-19 12:39:13
Could have a little better flow through it but it does the job
Mike.G
2025-04-13 21:50:18
The connector I received has a larger inside diameter than the usual flexible1 inch connectors. This means that it will not restrict the water flow when installed within a copper or PEX 1 inch line. This was easy to install because of its female connectors at both ends. I just removed the existing 90 degree pipe L configuration, curved this to a comfortable 1/4 circle, and attached it. The seals at both ends didn't require any thread tape for leak-free connections.
JHBerg
2025-02-22 16:17:58
Worked just like a charm for me - installed 3 for the softener and no leak issues. Dunno what type get for paying more. Was careful not to bend them around more than needed.
HHS
2024-11-30 17:43:15
We use these all the time for water softener and filter installations.Very reliable and well made.Washers don't leak or fall out.Full 1 inch flow not just 1" thread on a smaller 3/4 tube. They are full diameter to maximize pressure and flow rate.
RiverG
2024-11-12 11:12:58
Great product. Easy to use, and very sturdy.MKes connecting two pipes at almost any angle so easy.
Recommended Products
$15.85
$ 7 .99 $7.99