Your cart is empty.
Your cart is empty.
Premium quality real red oak wood veneer sheets
Red oak, flat cut wood veneer sheets are perfect for fine woodwork, furniture and cabinets. Easy to apply with contact adhesive, our oak veneer sheets will provide a high-quality, smooth finish to your projects.
Easy to use oak veneer sheets
Ensure you have a clean, smooth, well prepared surface, then cut the veneer sheets with a box knife or similar, apply contact cement to the substrate that will be covered, then apply contact cement to the veneer sheet with a roller. Smooth out any bubbles and you have a high-quality finish project, without having the expense of having to replace your furniture or cabinets.
Natural ready to stain oak veneer sheets
As this is a natural wood product, the color and grain pattern may differ slightly to what is pictured in the images. The veneer sheets are ready to stain and finish and are super sturdy while still being flexible enough to bend if required.
BUY NOW to restore and repair your furniture and cabinets with our real red oak wood veneer sheets.
Rebecca vecchione
2025-08-07 13:27:18
Worked for my project, good for the product I was working on.
Franklin
2025-08-04 10:09:12
I ordered this, expecting it to be a pain in the hiney to use, but I was wrong. I chose the width to match the table edge that I needed to repair, and the width was perfect. No sanding to fit! I tool my scrap piece from the damaged table edge and matched the stain color and glossiness at Home Depot. I came home and cut a piece to match the patch area (using a razor blade). This where I expected have problems: getting the glue to stick. I was wrong. Using the household iron on a cotton setting (dry), I quickly glued the 8 inch repair section in place. I thought the curve in the veneer would cause it to lift while the glue was still hot, but it didn't. After allowing it to cool, I lightly sanded it, then stained it to match. It took a couple passes with the stain to get it dark enough, but the end result was a pretty damned good match. I masked it off and sprayed a Varithane semi-gloss over th top, and it was done. Now, does anyone want to buy a table?
Timber Cruiser
2025-07-12 15:13:28
Used veneer to cover areas that could not be replaced by oak plywood. Looks great and stained easily to match other oak cabinet doors.
michelle dew
2025-07-06 15:17:25
I absolutely love this company! I do a lot of wood projects- and this company has saved my house! Their veneer is easy to work with, strong, and absolutely beautiful! I’ve used paper back and their psa veneer - and I can’t complain about ANYTHING! A few Pieces that arrived damage bc shipping- customer service swiftly replaced the entire pieces- and even over nighted the replacements- despite it not being their fault it was damaged. I won’t be switching “my wood provider†for a LONG time.
Big D
2025-06-14 18:12:32
This is high quality. I like the extra width as I used it on 3/4" oak plywood. It matched the plywood perfectly. I used a professional cutter to trim it up and then light sanding did the trick. I used an old clothes iron set on one notch from the hottest possible. I went over it and then used a dowel to rub it down flat and then slightly over the edges. I went over each piece a total of three times. I even had to go over a rounded portion on the end of a Wall-Bed and it held very well. I highly recommend this banding.
Dean
2025-06-06 19:40:29
This veneer was supposed to have an adhesive backing. It came with a paper backing only. Other than that the veneer worked great.
Robert D Jaggers
2025-04-08 18:21:05
It has a nice backing that makes the application easier plus strengths the veneer.
Mark
2025-02-05 10:15:02
Wood grain wasn't realistic believe it or not it was too uniform in design
Recommended Products
