Your cart is empty.
Your cart is empty.Jn
2025-08-28 17:48:48
I ordered this to go under the thermostat and it works just as intended. I think it looks better than just having the thermostat on the wall by itself.
Dale Hoard
2025-08-07 17:51:35
Great fit!! Covered up the wall from the old stat!
Walt g.
2025-07-24 18:05:56
I bought this because I installed a new hvac system with new thermostats that where slightly smaller than the previous ones. So instead of having to paint the exposed area I opted for this plate that worked well. It does have a round ish front that doesn't sit quite flush with my flat thermostat but it is barely noticeable. Had predrilled holes for easy install but I added a few others to fit my needs.
Bill Bertin
2025-07-06 21:50:15
Works fine as a generic plastic trim plate. But its a bit to large for the rheem econet thermostat. I still made it work. Though it could have come out a bit better if i had sized it correctly.
Placeholder
2025-05-22 18:24:20
I used these covers with a series of ST 55 Sensi thermostats. They were easy to put on and they look very nice.
Adam & Wendy Andrews
2025-05-21 15:04:52
Had to modify to make it work
Dale E.
2025-02-26 12:27:43
I used it to back a Honeywell RTH9585WF thermostat - it worked perfectly
mike l.
2025-01-15 12:55:01
Worked great
Recommended Products