Your cart is empty.
Your cart is empty.Product Description
It could be fixed on the wall according to the height of the car door to protect the vehicle door from damage from the bumper, body, and other places.
The semi-rigid foam prevents damage to vehicles and buildings, especially in areas with limited space.
The edge protector can be attached to the square column to protect the body in all directions.
Compatible with Various Walls
Instruction:
- Please clean and dry the wall surface and remove any particles on it;
- Peel approximately 4” or 10cm adhesive cover from one side and apply the protector on the wall.
- Slowly peel the rest of the adhesive cover and apply the protector on the wall at the same time to make sure it is straight and no space between it.
- Repeat the same steps above for the other side of your garage wall.
Notice before use:
- Please do not put under extremely high temperatures or exposure to the sun for long;
- Please clean the wall surface and remove the dust or other particles and keep dry before sticking the strips to the wall;
- Protectors can be removed without leaving marks on most of surfaces (e.g. brick, tile, glass, or marble walls). But the removal on a brittle or lime wall pavement may need to do it with care because the adhesive is very strong.
Wide Application
mnguyen
2025-08-18 13:41:14
Does a great job of protecting the wall and car doors, and also as a way to guide where my EV charger cable goes when I try and charge up my car, so it does do double duty very nicely. I would purchase this again.Sort of cons:Adhesion is very strongJust one caveat, when sticking it onto the wall, the adhesion is very strong so removing it will rip off the top layer of the dry wall. Just be sure where you want to stick it and for subsequent panels, I measured and level set it beforehand. Of course, I should've done that already but live an learn.Tip: use a cutting implement you don't really care aboutI used this on the pillars in my garage that required a bit more cutting to fit relatively nicely, so I would recommend using an exacto knife or scissor that you don't care about cause the adhesive is difficult to clean up afterwards. I did get the scissor cleaned up but took a bit of effort.
Mrmcg
2025-07-31 15:24:46
It took a great deal of time to make most of the adhesive stick to the protector so it would adhere to the garage posts. I would say only half remained on the protector the way it was probably intended. The other half I had to manually peel of the paper and it wouldn’t do so smoothly, so instead of full coverage, there are strips of coverage because the adhesive grid stuck to pieces of itself. I hope it stays up, but I suspect it won’t, in which case, it goes back to Amazon a mess.
V k
2025-06-14 14:27:57
The Garage Wall Protector Foam Wall Corner Guard is fantastic! It offers excellent protection for my car doors and garage walls, preventing dents and scratches. Installation was a breeze with the strong adhesive backing, and the high-quality foam is both durable and resilient. The sleek design blends well with any garage, and it provides peace of mind by protecting against accidental bumps. Highly recommended for anyone looking to keep their garage and car damage-free!
LowRider200088
2025-04-17 17:32:10
These were exactly what I was looking for to protect a corner wall and, more importantly, the car door when it swings open by "someone" in my household who might not be paying enough attention. My recommendation is to use Command strips to attach it to the wall because if you need to remove it or reposition it, you won't strip the paper off of the wallboard.
Andre Aragao
2025-04-08 11:39:50
the wall was not so aligned, and he still hid the imperfections. Very good product... however I added double-sided tape to prevent it from coming off.
B
2025-03-07 10:25:52
Overall quality of the foam is good. But trying to take off the adhesive protective sheet was frustrating and nearly impossible without damaging the foam or completely taking off all the adhesive from the foam.One of 4 pads were useless as adhesive came off completely with the protective sheet, 2nd one I tried to hold the adhesive to the foam while trying to pull the protective sheet, but ended up a ball of adhesive. The other 2 I had just enough to on the foam to get it work.The photo is one of the better ones I managed to use.
tony c
2025-02-04 13:50:03
Hope to keep me from the wall
Molly's Mom
2025-01-08 11:50:40
I bought these for the side of my garage entrance. Applied easily; however, this location gets afternoon sun and after 2-3 weeks the adhesive just gave way. My advise is to only use indoors or in shade.
Tamilee Finley
2024-12-31 11:02:18
I bought this product and my husband and I tried for 30 each to get the backing off the foam. It WON’T come off. This product is junk. So disappointing
J.J. Celis
2024-12-25 15:04:08
Imposible instalarlas, nunca pudimos quitar la cobertura del adhesivo para poder pegarlas. Una pérdida de tiempo.
Recommended Products