Your cart is empty.
Your cart is empty.This exhaust extension allows for safe venting of exhaust fumes from an unoccupied enclosed area. The buyer will receive: a custom low profile stainless steel exhaust stub, a high temperature flexible graphite gasket, a custom stub to 1-1/2” ID tubing adapter, longer replacement screws & hex wrench, the specified length of 1-1/2 I.D. flexible galvanized exhaust pipe, and the proper size U-bolt clamp. This design is compatible with the EU6500is & EU7000is inverter generators.
BigMike
2025-07-18 14:35:25
Simple but great product. Wanted to be able to run my Honda EU700is inside garage in order to keep it safe from predators. Obviously needed to vent exhaust. A 2.5" hole in garage wall (covered by plywood when not needed) and, bam, it's good to go. The parts here are high quality. Took me 10 minutes to install. Leave off generator when not needed. Great product that saved me lots of fabrication.
Gualberto Rivera
2025-07-09 16:45:29
I like the product because it extends the vapors away and far from contamination !
Michael
2025-05-16 14:50:51
Perfect fit as described. Great quality. Nice job.
Jared M. Black
2025-02-22 17:46:36
Easy to hook up. Fits like it should. What more to say? It's more sturdy than I pictured
Todd
2025-01-19 10:26:18
I am not sure if the 8' is too much back pressure on my quiet Honda 7000 watt inverter generator.I used the 8' to get it above face injury or burn height on the outside of my metal building, but there seems to be a lot of exhaust inside the building (window open) I am thinking of cutting it down to a couple of feet and cutting an additional hole in my new metal building and patching the old one. But it will be down at little people height.
Customer
2025-01-17 15:01:42
I needed this for Hurricane Ian. I had the generator in a shed with a fan, but the exhaust buildup in the shed was too much.The most difficult part of the installation was the removal of the Honda screws, wow, they were on tight.I had worried the tube would create a loud exhaust sound at the end, but it was surprisingly quiet.The threaded adapter was also a nice touch. When putting away the generator, I simply unscrewed the tube which was convenient for storage.The only problem I had was unpacking. The gasket broke when I was opening the plastic wrapper. Since I had the generator in a shed, some leakage was not a problem. But be careful opening up the parts.
Frank H.
2025-01-09 13:32:38
I wanted something to get the exhaust from my Honda Generator outside of the shed. I bored a hole through the wall and directed the exhaust pipe through it to the outside. Works great and no exhaust smell in the shed.
Bill & Jane
2024-11-25 15:46:54
I thought it was a bit high priced, but it is exactly what we needed, included very good hardware and instructions.
Recommended Products
