Shopping Cart

Your cart is empty.

Your cart is empty.

Heavy Duty Toggle Switch 20/15A 125/277V, 2 HP with Waterproof Rubber Boot UL cUL Certified

Free shipping on orders over $29.99

$7.96

$ 3 .99 $3.99

In Stock

1.Size:1 Piece Pack


About this item

  • Heavy Duty 2 HP 20/15A 125/277V AC
  • Lead Wires up to 12” in Length !
  • Sturdily Constructed Body, ½” Panel Opening
  • Silicone Boot, Gasket and On/Off Face Plate Included
  • Suitable for Automobile, Home Appliance, Industrial Control and Other Industries


* Heavy Duty 2 HP 20/15A 125/277V AC
* Lead wires up to 12” in length!
* Sturdily Constructed Body
* Silicone Boot and Gasket Included
* ½” Panel Opening
* Preassembled with On/Off Face Plate
UL Recognized Special Use Component, File # E355116 (WOYR2)
UL Recognized Silicone Boot/Combo, File # E313209 (UYMR2)
UL Sam Manual
DIMENSION: 1-1/4" x 5/8" x 1-1/16" ( L x W x H )
Amazon Protected Money-Back Satisfaction Guaranteed


fred goodrich
August 19, 2025
God switch, worked well in exterior box. Has rubber boot on lever to keep hands off metal in out side uses.
Joel
July 12, 2025
The switch is heavy duty and switches with appropriate amount of pressure. Durable enough to switch off and on with foot without having to worry about damaging the switch. I wired with a redLED light to indicate in the on position.
Chris H.
June 7, 2025
I installed LED lights on my snow thrower. It was hard to find a switch that would clear a stabilizer bar and not be in the way of moving parts. I came across these and bought to try. They met every need and they are water proof as well. In the picks above there're two switches, one for the stock light and one for the LED's.
jpg
May 29, 2025
I needed a waterproof switch that didn't have an LED, and this fit the bill. The waterproof cap didn't go on super well, but other than that, it works as advertised.
Gabe S
May 19, 2025
Devise works as described, and feels sturdy. Only thing to note is if you want to use the rubber “water proof” cover over the switch, you will need to clean excess rubber from the inside threads of the rubber nipple to screw it on all the way. I put water proof in quotations as it does not really help much unless you install this somewhere where no water will get behind the mounting surface, only on the top side. Light rain or splashes will be okay but submerging this will for surly cause corrosion and the part will fail. Installation was at easy, drill a half inch hole and place it in and tighten down.
Laurie Koch
April 25, 2025
Does the job.
Customer
April 13, 2025
My misake....was looking for a toggle for my parents 1956 bathroom mirror/florescent light fixture; I should have measured. Way too big....but seems like nice quality!
David
January 31, 2025
I used two of these switches for my 16 ft aluminum boat. One for my running lights. One for my bilge pump. They appear to be watertight whereas the switches I replaced corroded at the back of the switches where they were not sealed.
Recommended Products