tony perryman
2025-08-07 17:41:05
Perfect fit works great .very easy to install worth every penny spent
Jack O Trades
2025-08-04 11:57:16
Replaced the factory distributor after 240k miles. Fits and functions as should. Set camshaft position correlation . Also replaced replaced crankshaft position sensor. Engine runs good with no misfires or codes.
Rhonda M
2025-07-27 10:01:15
After installing this distributor correctly 5 times, I got it to work by knocking the pin out of the drive gear and rotating the gear 180 degrees on the shaft and reinstalling. Fell right into place, oil pump and all. Started the truck and no more P1345 code. Truck runs smooth.
Robby Jarnigin
2025-07-23 11:02:42
cheaper than parts store
Joshua Henson
2025-06-04 12:40:24
This distributor is machined and assembled solid and nicely. It’s far better than the old plastic shaft one I removed. This one is full aluminum. I used a different cap and rotor that I had purchased due to some other reviews mentioning the ones that came with it being a little on the cheap side, but the unit itself is worth every penny. It fit in perfect and brought my truck right back to life.
Semper Paratus
2025-05-05 18:37:39
Fits fine, however the terminals on th cap are not brass. The only "brass" is on the tip of the rotor. I kept it because it was badly needed for a project. I plan to replace it with an OEM one.
Wayne Hedrick
2025-04-05 10:01:21
Works great no issue's
The Garbage Man
2025-03-01 13:13:08
One in the tool boxes of each truck. Not IF but WHEN they fail , the repair part is on hand and ready to go.
Juan garcia
2025-02-17 13:19:21
Ajuste perfecto en tahoe 1997 vortec v8 buena calidad de materiales recomendable
Ryan S.
2024-12-25 21:04:00
The cap and rotor fit perfectly on the 454 in my 98 Bounder. Reuse the stock screws. You’ll need a t20 and t15.