Your cart is empty.
Your cart is empty.Product Description
The 6-speed LED wall fan speed controller includes White, Light Almond and Ivory fan control switch faceplates, a full range light dimmer and independent uplight/downlight operation. This ceiling fan control switch has 1-touch reverse features and a 1.0 amps fan load for hassle-free access when optimizing your preferred settings. The SW605 fan speed controller uses the RC188, RC212 or RCK55 horseshoe receivers (sold separately).
From the Manufacturer
Six-speed LED remote control.
Papa Sierra
2025-09-02 09:19:22
The Emerson fan I bought only came with one remote - a handheld design. I purchased the SW605 as a second controller to mount on another wall. Remote wiring was already there, so installing this unit was a snap. Very satisfied with the six speed Emerson fan. Lowest speed is a gentle breeze for sleeping and max speed is a category five hurricane - great for cooling down after a workout. Super silent operation too. You only hear the wind.
Ray
2025-09-01 13:00:26
It seems the origional switch I had failed, this replacement works great.
Chenandler
2025-08-08 10:39:22
These seem to last only about two years. They fail, and the fan starts misbehaving, with the lights turning themselves on and off randomly for hours on end.It's a shame because the Emerson eco series fans are the best fans we've ever owned.But having to replace a $50 control every two years is just ridiculous.
usna98
2025-06-23 17:47:53
I purchased four of these to replace some 4-speed Emerson fan switches that were previously installed in my house. Those old 4-speed switches did not work properly with my new 6 speed Emerson fans, and if the switch positions were accidentally changed, there was a potential to damage the new fans. I did not particularly care for the remotes that came with the fans as they were easily misplaced. I purchased these switches "used" from the Amazon marketplace as they came at a huge discount from the retail price. It's a little hard to justify spending $50 on a switch for a fan. In any case, installation of these switches was a piece of cake once I mapped the wiring from the old switch over to this one. If, like me, you have an existing remote control fan switch, you need to ensure that the toggled RF settings match up to whatever you selected for your remote control, so that both the remote and wall switch can control your fan. Once you've matched up the settings, there's no need to re-sync the fan to the switch and remote. Also, as others have mentioned, the presence of an upper and lower light bulb switch isn't very intuitive. You will use the lower light bulb switch to turn the fan light on/off (most fans have this type of light configuration). If you happen to have a fan that has a separate, upper light fixture, then you would use the upper light bulb switch. Oddly enough, one of the switches I received only had one light bulb switch (maybe that is an older or newer design - either way, it's more intuitive). Time will tell how reliable these switches are, but I've had them installed for a few months now and they work like a charm. Recommended!
Karl N.
2025-06-12 15:53:28
I used this SW605, along with an RCK55, to replace the failed switch and receiver in our Emerson CF4800 ceiling fan. A caution: this could be a difficult retrofit for many people. I had to remove the ceiling fan and then trace out and re-route/re-wire the fan up to the ceiling box in order to get make sure all the connections would match the newer RCK55 interface wires.But, with that done, the SW605/RCK55 combination is working great with our fan. I now have full control of our up and down lights (including dimming), and the fan speeds (including reversing direction) all from the wall switch.
yazfan
2025-05-31 16:56:44
When we bought our house, the bedrooms had ceiling fan switches - the kind with two sliders. They all had broken handles (they get terrible reviews for this). Went for this one instead, and we like it a lot. Its a bit complicated, and not intuitive, but much better than the other kind. The light buttons are misleading (not two for dimming one light, but two for two lights if equipped). Otherwise, it works very well. Its really nice to be able to reverse direction on the fly.
Big Deahl
2025-05-02 17:14:49
These speed controls are really nice and easy to install, if your fan is compatible get it.It can be challenging to put back into the switch box so make sure you push/dress your wires as far back into the box as this is a deep switch.
Dave & Patty Hendricks
2025-04-20 10:38:42
I bought and installed this controller a year ago. All functionality works fine. One of the incandescent bulbs failed recently and I replaced both with dimmable LEDs. The LED bulbs act like they were installed in an incandescent-only setup: they flicker when dimming and do not reach full watts when I set the dimmer to high. Clearly, this switch is NOT for LEDs, regardless of what they claim.
Customer
2025-03-22 17:10:09
Restored full control of the ceiling fan that had been rendered non usable due to a failure of the original controller
L'acheteur
2025-03-01 21:44:05
C'est une quasi nécessité. Adieu les télécommandes qui traînent partout.
Daniel Laplante
2024-11-28 09:17:01
Ne résiste pas ils sont venus avec les ventilateurs nous en avons 18 au total dans la villa ils brûlent facilementThey came originally with the fans , we have 18 in total they burn to easily
G King
2024-11-13 13:25:24
Was described as "new". When I opened the box , it had obviously been used and was missing the screws.
Recommended Products
$48.08
$ 25 .99 $25.99