Your cart is empty.
Your cart is empty.Product Description
Very High Bonding Double Sided Tape
Industrial Grade 2 Sided Mounting Tape - Widely Used:
Very high bonding tape works extremely well on smooth surfaces and widely used for LED strip lights, trims, car registration plates, name plates, address plaques, signs, emblem, car holders, mosquito/bug screen, metal mailbox, mirrors, hangers, tooth brush holder, photo frames, power strip and other automotive home office decorations.
This double sided mounting tape is an industrial grade Acrylic foam tape, more stable and better initial adhesion which is good for permanent and reliable installation indoor, particularly in exterior applications where extreme weather, moisture and adhesive is needed. The longer applied the stronger it will hold.
Super sticky strength that can withstand moderate to heavy mounting with peel adhesion up to 20lb/in and tensile strength up to 90 lb/square inch as tested on stainless steel. Holding weight is based on objects with a maximum depth of 0.75”.
The PE film liner might be difficult to peel if you do not have nail; you can Use a knife to cut out the backing film a little bit or Pinch and stretch a corner of the adhesive until the backing liner lifts from the tape for easier liner removal.
WARM THE ADHESIVE SIDE UP IN COLD WEATHER BY HAIR DRYER FOR BETTER INITIAL BONDING.
Industrial, Home, Car and Office Applications:
Simple Steps for Application:
1. Clean the surface as per application guidelines and keep it dry.
2. Pinch and stretch a corner of the adhesive until the backing liner lifts from the tape for easier liner removal or use sharp tool to cut an open on the film backing liner.
3. Cut the right size you want and stick it on the surface of object, if you are going to mount over size and heavy object, let the tape cure for at least 12 hours to create a secure bonding first and then stick to the wall.
4. Give a HARD PRESS if you are sure about the position to objects and wall.
5. For some surface if the tape does not work, spray Adhesion Promoter first then stick the tape.
NOTE: Never use this tape on any type of PAINTED DRYWALL which might cause damage to the paint.
Acrylic Tape - Curing Process for Adhesion Percentage:
The surfaces should be thoroughly cleaned with a 50:50 mixture of isopropyl alcohol and water. Accomplished when temperature is between 70° and 100°F (21°-38°C) and the bond is allowed to dwell 72 hours. Initial tape application to surfaces at temperatures below 50°F (10°C) is not recommended.
What should I pay attention to make my application work?
- 1. Make sure the applicaton temperature is around between 70° and 100°F.
- 2. Press the tape against the object and wall as hard as you can.
- 3. Use a plastic roller to clean the air between object and adhesive.
- 4. For some surface if the tape does not work, spray Adhesion Promoter first then stick the tape.
- 5. Permanent double sided mounting tape, not suitable for temporary use.
- 6. Never use this tape on any type of painted wall or it will damage your painting.
Specification of Size:
1. Model Number: Comparable with 5925 and 5952.
2. Roll Width: 1/2 Inch, 1.0 inch and 2 Inches.
3. Color: Red film backing.
4. Wrap packed.
What steps should I follow while applying?
1. Clean the surface as per application guidelines and keep it dry.
2. Cut the desired and stick it on the surface of object if you are going to mount over size and heavy object for at least 12 hours to create a secure bonding first and then stick to the wall.
3. Give a hard press if you are sure about the position.
Temperature Resistance
Short Term: (minutes, hours) 300°F (149°C)
Long Term: (days, weeks) 250°F (121°C)
Easily handling the heat in car at sumer season, working under direct sun and performing the same bonding strength under high watts LED strip lights.
Waterproof and Moistureproof
Excellent water and moisture resistance once the curing process is done, which taken 24 hours. BUT DO NOT stick the tape onto any wet and oil surfaces for initial application, these environmental conditions affect the bonding strength or even weaken the performance; always CLEAN & DRY surfaces first.
Heavy Duty Bonding Strength
Peel Adhesion: 20 lb./in. width (350 N/100 mm) based on stainless steel
Normal Tensile: 90 lb./in.2 (620 kPa) based on aluminum T-block.
Dynamic Shear: 90 lb./in.2 (620 kPa) based on stainless steel.
Kel
2025-08-28 15:04:39
I've used this tape for so many things and it works great! Last use was to secure my grill on my car. It was a little loose. Holds it nicely
RonF
2025-08-14 13:37:09
Very sticky and tough........probably the best double sided tape there isStuck where several others had failed to do soA+++
Kindle Customer
2025-07-19 12:57:23
I use double-sided tape for various audio install applications. This stuff isn't bad, but it doesn't hold as well as its 3M counterpart, in my opinion. If you have any weight on it or need it to hold for a long time with gravity working against it, I'd consider another option.
Joe G.
2025-07-14 13:54:46
I bought this after watching several videos about double sided tape. They weren't wrong, this stuff is incredible. I don't recommend placing it flat on a surface that might peel off such as rubber lining in a toolbox or a table cover. Even the edges of this tape will rip it off.
Anna Bailey
2025-06-24 10:10:37
This works just as good as the 3m brand! Great value!
Brogren802
2025-06-20 10:33:41
I used this to hold rain visor on my car after the original tape failed and only did a small section until today. I had a hard time removing the tape to reapply it and it took forever but having a clean surface is necessary. This is by far the best double sided tape I have ever used beating 3m and gorilla brand tape. This is the best you can get
Big Bob
2025-06-16 16:57:28
So far it seems to be working well. Good and sticky. Only time will tell if it will last especially in different temperatures. No issues as of yet.
Ricanron
2025-05-31 15:28:43
The media could not be loaded.
Gouche
2025-04-30 10:45:43
I bought this to help secure my over the door shoe rack. I cleaned and dried the area, applied the tape according to directions and waited 24 hrs (well closer to 36 hrs) then put my shoes on the shoe organizer. Two days later, I open the closet door and the shoes all fell through the organizer as the tape had let loose. I had adhered the rack in 6 different spots so it should have held till doomsday. Needless to say I am not impressed.
Blane
2025-04-02 14:20:42
Great product
Homebody
2025-03-05 10:08:47
Excellent, strong, works grwat
DMD show systems
2025-02-25 14:43:55
This tape is very versatile, at a rating of 8lbs per sq inch, I’m not certain I required that but what I did fine is that once applied and several hours have passed… the tape will be very bonded to the surface… but… you can pick at an edge and then remove it without any structural issues… it cannot be reapplied after removing or I would not suggest trying… this is an excellent price for the amount you get and I will be buying quite a few more
tracey sayers
2025-01-17 17:06:17
Great product to use. Very sticky just needs a firm press. I have tried to move this and it's most definitely stuck. Great product and well worth the money
Recommended Products