Your cart is empty.
Your cart is empty.Product Description
Dave in GA
2025-07-26 18:01:24
Works like intended, great for starting holes.Sharp and accurate.
Dano
2025-07-17 12:54:09
Use in my M12 90 degree drill/driver. Fits everywhere. I have only used on steel and holding up great
Greg Pine
2025-07-03 18:32:27
A very sharp and aggressive small step bit. To clean up or make a hold, it's in a class by itself.
Customer 523
2025-06-06 20:19:40
Good
Jonathan Johanneck
2025-04-27 15:39:09
I needed to drill 2 holes and this bit couldn’t even do that job.. Very disappointed in the quality and considering it wasn’t a cheap step bit..My $7-8 Harbor Freight step bits actually work and last quite a long time
Mark Fife
2025-04-06 15:38:44
Cuts fast, and aggressively, so make sure got a hold of your drill and work piece. Because of the 4 flutes, the hole is not truly round. More of a pentagon, but might do better if you can cut slower.Update: Because of the aggressiveness of the cutting. Its now has a chip out of 2 cutting surfaces. And it feels like I have a sprained wrist!
Michele Ward
2025-02-26 19:44:03
bought to put holes into metal building studs. took quite a while for each and you push so hard to get through, you end up taking it too far in and a bigger hole. If you looking for bit to go through those steel steel studs look at titanium.
terry tanner
2024-12-22 12:34:42
I was using Milwaukee 3/8 step bits, then I discovered this product! I think they are actually better than the Milwaukee product, and much easier to get!
Recommended Products
$19.93
$ 8 .99 $8.99