Your cart is empty.
Your cart is empty.djpavao
2025-08-29 19:21:41
Was what I wanted
Richard H.
2025-06-22 11:13:39
worked as described
Jersey John
2025-06-18 18:59:27
Liked having 1/4" shaft and snap on capabilities.Liked getting a case for the bits.Disliked markings are not white and difficult to read, and the steps seem too shallow.
Brad N
2025-06-06 16:10:09
I've only used a few times so far but they are ridiculously Sharp and hold an edge
Jordon Musser
2025-05-14 18:50:16
Stays sharp and drill great. Very happy with the product and even after I broke one (my fault!) they helped me out.
cvtkid
2025-02-16 17:50:26
Like the tool, but if you move , the tip of the drill breaks off. Way too long and is fragile. In a drill press it was fine. In a hand held drill, tip does break off. When the drill is new, it grabs the part. Need some relief on the tip.ok tool
JWill
2025-01-14 10:49:17
I have had every single one of these break in mild steel, all the same way, and because they split in half, it's plain to see that they are chinesium and not Cobalt. I would be shocked if they contained any cobalt whatsoever. Every one of them would heat up at about 50% of the bit and the bit would struggle, as I would rock it to get it to bite, it would bite, and then snap. These things are grade a junk. When I find them again, I will post pictures, they are an alloy blended something, but certainly not quality.
roger d.rowe
2025-01-04 17:58:18
well worth the money, and is holding up to use very well
Recommended Products