Your cart is empty.
Your cart is empty.Product Description
Nickel Plated Brass Busbar Contact
The plate has high conductivity, corrosion resistance and low resistance. And the oxidation resistance is very good to extend the service life.
6#8 Stainless Steel Terminal Screws
Come with 6 Stainless Steel Terminal Screws. Simply insert the wire into the ring terminal, and then pass the screw through the terminal to fix it on the terminal block. Allow terminating for one or more connections.
Removable Polycarbonat Cover
The removable plastic insulating cover offer good heat resistance. And it prevents the metal parts from coming into contact with anything to ensure safety.
Lennox D. Lampkin
2025-08-24 15:37:02
Good build quality. Highly recommended
Joshua
2025-07-08 11:19:43
Nice piece of kit to have with a small solar setup
John Ason
2025-07-02 11:37:18
These Bus Bars may be inexpensive but they are solidly constructed and as long as I use them within their tolerances I expect years of service from them. Thanks for delivering a quality product at an affordable price!This is my 2nd order of this product. The wrong item was shipped, (3 pairs women's stretch pants?)But the Amazon customer service lady took care of that quickly for me and shipped the proper BUS Bars out the same day! We all mess up sometimes, Thanks for making it right Amazon!
J. Young
2025-06-20 18:30:08
The combination of the larger posts and the smaller screws makes it easy to connect large gauge and small gauge wires with different terminals. I’m using this in my off-grid shed solar project, and it’s so much easier than forcing multiple connections on a single point. Plenty of room for growth with my system.
Michael Peryer
2025-06-08 10:19:35
I connected my battery, inverter and dc controller to this block. 5/16 bolts. Worked great.
Timothy B. Sabo
2025-05-05 10:51:40
Worked great in my Polaris Ranger
Nick S
2025-02-18 16:32:21
This are bigger than expected but I'm not complaining because they handled 170+ amps through individual lugs without heating much at all. The design is really nice, two of the lugs extend further than the others and hold the cover on with nylon insulating nuts. I made my own bus bars to connect laterally from the studs to some 200A breakers on each side, and didn't have any trouble setting everything up. This bus bar and it's screw terminals are overbuilt enough that when the lugs are tightened down, it feels like it becomes one solid piece with everything attached to it, with no wiggle or play at all.You can unscrew all of the smaller screw terminals which go down either side, leaving the entire surface around the large lugs free if you need more surface area for contact to handle higher amps. The plastic cover is also easy to trim with side cutters if you need a few more millimeters of clearance around the edges for large connections (it doesn't shatter unpredictably like bakelite would).
lil bear
2025-01-27 17:14:32
works perfect for battery deletes!
Richard
2025-01-23 10:29:14
RV install
Recommended Products