Your cart is empty.
Your cart is empty.Product Description
NIXFACE:
Driver and Passenger Center Skid Plate Frame Rust Repair Fit For Jeep Wranglers TJ 1997-2006.
NOTES:You need to drill a hole if you weld on your Jeep TJ 2003-2006 model,IT will require slight modification and use screw.
Rear Set Trail Control Arm Frame Rust Repair Kit
Product function:
- NOTE:Please make sure the fitment before your purchase.
- Used this replacement for your TJ wrangler frame due to it being rusted out,Reduce your costs.Make your Jeep back on the roads and trails.
- Welded this rail in on passenger and driver side. Was heavily rusted through before and now good as new;
- Item exactly as the pictures showed.
FEATURES:
product description:
Skid Plate measures approximately 43-1/2" end to end, full length repair pieces that completely repair the areas in front of and behind the skid plates.
Made from high strength 10 gague steel. Thicker than your existing frame.
New Upper Control Arm Fastener hardware to make your installation easier.
- Avoid a Costly Frame Swap,Reduce cost;
- Save time, do it yourself without going to the store;
- Get Your Jeep Back on the Road in Less Than a Day;
Easy to install:
Remove the rusted old, clean, then weld the new piece on.
Material
Vehicle Fitment
Power coated
Install Easily
Thank you for your trust in NIXFACE.
- We look forward to your valuable suggestions, and we will continue to improve our products.
- Many of our products are improved based on suggestions.
Lee
2025-08-24 13:35:15
The frame rail repair pieces fit good!
Dave
2025-07-30 11:15:17
A bit of a tight fit but believe it will.work.
Customer
2025-07-11 12:46:33
I ran into the whole ripped out nuts in the rusty frame while doing a clutch routine. Found these guys in like 2 seconds. Got them in a couple days. Cut out the rest of the trapped nuts to make room for the new ones. Hammered these guys into place. Did a little surface prep for my welding. Hammered real tight up front and welded there. Used a screw jack to let the weight of the jeep press the back up tight. Welded that. And then hit several welds along the way. The only curve ball I ran into was my jeep was lifted and needed longer bolts. If you run into this the threads in the new frame were not the same thread size. No big deal. Ordered what I needed and I was good to go. Everything lined up perfect and everyone was really impressed with how nice they look. I would highly recommend these.
Jon keller
2025-06-05 15:26:47
Pretty good deal for the price , they take a little Persuading to get to fit right definitely fit very tight !
Christopher Dail
2025-04-21 15:32:11
Received the product in a timely fashion. Comes painted or primered. This has to be ground off before welding. Fit was fair. Had to do a lot of adjusting to get it to fit. Transmission skid plate bolt holes didn’t line up. I’ve used other companies before at a slightly higher price. I would not use this product again to save a few bucks
Christopher Heberer
2025-02-04 18:22:33
These do not fit at all. They have to be cut and modified. All the cutouts are in the wrong spots. Horrible design. Bends for the frame are also wrong. Off by about. 75" Do not buy these. Just make your own.
Recommended Products
$394.99
$ 99 .00 $99.00