Your cart is empty.
Your cart is empty.Product Description
OTC's specially designed wheel bearing locknut sockets make wheel bearing locknuts easy to remove or install. OTC wheel bearing locknut sockets are formed from high-strength steel that is resistant to rounding out under high torque loads. Designed for use with 3/4 inch, square-drive MANUAL tools only. NOT intended for use with impact tools - use with impact tools will void the socket's warranty. 6 point, 4 inch (flat to flat) opening size. Measure locknut from flat to flat to determine socket size needed. 5 inches deep to ensure spindle clearance. Value is at the core of the OTC tool and equipment portfolio. For a simple repair or the most complex drivability concern, these award-winning tools universally solve problems faster, and at better value, than any other product line available. Whether it’s a specialty tool or unique piece of service equipment, OTC provides top solutions to modern automotive service challenges while increasing technicians’ productivity and shop profits.
From the Manufacturer
Wheel bearing locknuts are easy to remove or install with these specially designed sockets. They’re made of high strength steel and resist rounding out. Measure from flat side to flat side of locknut to determine size needed. Note: Sockets are designed for use with 3/4 inch square-drive manual tools only. Impact tool use voids sockets’ warranty.
William
August 24, 2025
This socket was a exact fit and no issues with using it.One of the better high quality sockets for heavy vehicle axle bearings.
Jiusi
August 17, 2025
GREAT TOOL FOR ALL MECHANICS! you can trust this brand for ever!
Ismet Merdzic
August 5, 2025
Works as it should, used it to remove drive axle nuts on my Peterbilt 379.
David Steele
June 5, 2025
Working on large vehicles, having good tools is important. This definitely did the job.
Sam Y.
May 11, 2025
It was nice and easy working.The 90hp new-holland tractor front hub nut repaired.
Crowder
May 3, 2025
QUALITY ITEM
Mart
March 30, 2025
Used this tool to change wheel seal on my freightliner Cascadia. Love it
N9GIK
March 8, 2025
What do you say about a socket? Smooth finish, fit the nut, balanced in my hand ? Took the nut off my truck axle and put it back on. First time I needed a 4" socket in 60 years and possibly the last. But it did what I needed.
Ohnoiboughtmorestuff
February 18, 2025
Exactly as advertised
Rangerider
February 14, 2025
Works
Recommended Products
