Your cart is empty.
Your cart is empty.Quartz Dish 25mm Outer Diameter, 9mm Inner Diameter, 12mm or 17mm Tall, 5 Dishes Total
Customer
August 31, 2025
The nut that goes down inside the center of the Banger to hold it in place is 8.8 mm in diameter the hole in the center of the Bangor needs to be at least 9 to 9 1/2 mm it is not they will not fit very disappointing
Mary Wooten
August 9, 2025
Fit our enail just like the original, I've tried several smoke shop in my area with no luck. My wife found these, seem to clean up better than original bowls after heavy use.
Customer
July 9, 2025
Center hole too small for the nut.
Dennis
July 6, 2025
These quart dishes are made well, unfortunately, they did not fit my set up because the interior diameter is too small.
dilemmantrauma
June 9, 2025
Does not fit.
L.M
February 13, 2025
Beware. If you have a 20ml coil, DON'T buy these. They won't fit in the middle, too small. I will say that they are well made! Highly recommend for smaller coils. Again, SMALL in the middle...
Customer
January 17, 2025
They arrived pretty fast, in good condition, and we have been able to use only one of them since we got them
Bennett
December 12, 2024
This will not work with the common titanium nail and coil setup. I slowly worked up to 900 degrees because it wouldn't get above melting product. The miniscule amount of vapor I did get didn't taste good either Not sure what this possibly works with.
Recommended Products
