Your cart is empty.
Your cart is empty.Product Description
Prevents Leaking
Provides a TIGHT SEAL to prevent leakage, this will cut down on wasted water down the drain
Top of the line
This is the latest design of stainless steel filter mesh in the middle of the rubber washer.
It also serves as a flow restrictor cutting down on water waste.
Universal Fit
It is a universal fit of 3/4" for all shower heads
Cee H
2025-06-16 12:18:01
Fit was fine for both sink and shower.
joe
2025-06-15 20:17:05
The gaskets were well made and the shipping was fast. They worked well in my shower heads, and the price is reasonable. The package came with a very nice little thank you card, that was a nice touch.
ANDREW BUTUSOV
2025-06-09 17:20:41
I tried a few different seals from the hardware store with no luck. Took a chance on these seals that looked exactly like what I needed and the hardware stores seemed to not. My leak is fixed! Be careful to not over tighten shower head or you’ll cut the new seal. Definitely recommend these!
Marina
2025-05-18 16:33:27
the washer kept my bathroom dry
Carmen T
2025-03-30 16:58:25
Took a shower head off, replaced it. The one I removed was still in good condition, except the shower head gasket was a bit beat up. Measured, ordered, they came quickly and fit exactly. Now that shower head is a fully equipped back up. Thanks!
Aag
2025-03-25 13:48:15
The gaskets are reasonably priced, but slightly undersized. It is very difficult to get a tight seal.
Luis Sierra
2025-01-31 11:43:10
Check all the local stores and nobody had them. These fit perfect just as advertised.
Florida Becky
2025-01-03 10:55:12
I had a brand new shower head in a box and another shower head that had been used. I took the washer out of the new shower head and put it in the used shower head that I wanted to install. So now I had a brand new shower head without a washer. Was surprised to find at one of the big box hardware stores -- the orange one -- that they did not sell shower head washers. So I turned to Amazon to purchase these. I installed the brand new shower head with one of these washers, and I get a very very slow drip from the threaded attachment point - maybe one drop every 30 seconds. I used teflon tape like always and it is a new Moen shower head so that leaves me thinking it's the washer at issue. Not enough of a leak to obsess over, but it seems like something as simple as a washer should work.
bill kupczyk
2025-01-02 14:57:03
Great product
Recommended Products