Your cart is empty.
Your cart is empty.Product Description
A Sleeve Bearings (also known as a bushing bearing or plain bearing) is a straightforward and fundamental type of bearing.They are primarily used to guide or reduce friction in linear applications. In high temperature and corrosive environments, brass bushings still allow high sliding speeds. They have good load capacity and wear resistance.
Sleeve Bearing Self-Lubricating Plain Bearings Wrapped Oilless Bushings
Material: The bushings made of carbon steel base with a bronze sintered and composite coating, offers high mechanical strength and excellent thermal conductivity, making it good for diverse applications across both low and high-temperature environments.
Application: Wide application such as textile machine, printing machine, hydraulic loader, fitness equipment, agricultural machinery and other industrial equipment.
Fearture
- Material: The bushings made of carbon steel base with a bronze sintered and composite coating
- Wrapped Bushing is self-lubricating
- Solid friction Oilless Bushing
- Oilless Sleeve Bearings
Andy Maupin
2025-08-21 16:22:33
The items arrived quickly, in perfect shape. They measured perfectly. I used these bearings as spacers for a project and they worked great.
Phil L.
2025-06-17 10:21:33
If your expecting these to be 9/16" outside diameter your gonna be disappointed as I was and several other reviewers because the OD is quite a bit larger then 9/16. The inside diameter seemed to be right (1/2") but I had to grind down the OD quite a bit for them to fit which made for a sloppy fit and defeats the whole purpose of having these spacers.WOULD NOT RECCOMEND UNLESS YOUR OKAY WITH TOLERANCE BEING MORE THEN 1/16" OFF
Victor R. Prince Jr.
2025-06-10 17:05:59
I ordered these to make a tight-fitting swivel hinge for a workbench. The set I ordered should be 5/8" ID and 3/4" OD. The inside diameter is fairly accurate, but the outside diameter is under by about 3/32" which is massive for something like this. Luckily I did a test to see how tight the hinge would be and realized it before I drilled my actual workpiece. It's pretty obvious now that I know and I'm surprised I didn't notice that the bearing wall is thin, around 1/16" which would make the claimed od impossible.Anyway, I can still use them but depending on your application you might not be able to.
Gayle G
2025-06-03 14:25:51
As advertised nice bearings. Nothing to complain about.
Todd H
2025-02-23 15:23:06
These bearings were .030" undersized on the OD and have a large seam both on the OD and ID of them. They're junk.
David Nisbett
2025-02-09 17:22:53
Was.600 od was supposed to be.562
Coffee Brewer
2025-02-05 18:53:40
These sleeves are very slim and work well. I have a stainless steel pipe that goes through it and it works great.
LMac
2025-01-21 11:42:11
Outer diameter is approximately 1.410" when should be close to 1.437 (1-7/16). Bearings sit loosely and spin freely in a 1-7/16 bore and therefore aren't useable and are being returned.
dReZ.ReVuZ
2024-12-23 11:46:20
too big to be usedthey are nice parts but they are too big to serve their function for moi
Recommended Products