Your cart is empty.
Your cart is empty.Universal ladder will fit any full size van. Manufactured from thick gauge aluminum tubing with a bright dipped polished finish. Flat grooved non-slip steps for added safety and installs with stainless steel hardware.
Steven
2025-08-28 09:11:45
The media could not be loaded.
Anamarie Fox
2025-08-14 15:35:46
Pretty good for a lightweight ladder. It is pretty solid though
Wanda Roberts Cason
2025-08-10 15:01:54
Perfect fit, and looks nice.
Elking
2025-06-17 18:28:24
This is my second latter the first one I installed on the rear door of my Ford Econoline 350 which fit very well and is very sturdy at 1 inch aluminum tubing.This one I plan on making it longer to use on the driver side of my Van. At 7/8 aluminum tubing I don’t know if it will be as sturdy as my first one?Description says it’s 56 inches long but it is only about 51 inches tall
Porn-Hair
2025-06-09 14:04:42
Workx
Troy A
2025-05-26 10:00:00
Great ladder! Very sturdy!
Stalina S.
2025-05-13 10:42:45
Returned. Item was not correctly put together by the manufacturer. Called the manufacturer surco and they could couldn't care.
Dale Anson
2025-03-05 15:13:23
I contacted the manufacturer directly about their ladders, the "fit guide" is on their website:"I have a 1998 Dodge Ram B3500 Van. Your fit guide says the 103H ladder will fit, however, several reviews on Amazon say that the 103H it too tall to fit. The back door on my van is 50 inches tall. If the 103H is in fact too tall, would the 103 Universal Van Ladder fit? Also, what would be the clearance between the ladder and the door? My van has a spare tire holder that sticks out from the door 4 inches. Would the ladder stick out far enough to clear it?"Their response:"The 103H will probably be too long. The 103 will work on the van due to the fact that it bolts on at all 4 points. The 103 has a 5†clearance, so based on your measurements it will be very close but should clearing your tire carrier. "Based on this, I ordered the 103 ladder. It does not have enough clearance to go over the spare tire holder. My solution was to install the ladder UPSIDE DOWN (!). I put the flanges at the top and used the sheet metal screws, then used 2 U bolts to attach it to the spare tire holder. It clears the bumper at the bottom by about 1/4". It looks and works fine, but really that's not right.
jos10000
2025-01-30 16:06:28
pour vr
Bill E
2025-01-19 17:41:17
Be gentle on it, kinda flimsy but works
Recommended Products
$286.71
$ 99 .00 $99.00