Your cart is empty.
Your cart is empty. Tow Without the Rattle: The peel-and-stick anti-rattle trailer hitch silencer available, Our trailer hitch silencer for 2" hitch, If you want a quiet ride with no hassle, Our Hitch Silencer is for you.
High Quality Materials: Our Hitch Silencer shim offer Outstanding impact strength and sound dampening, which is stronger than nylon and some metals rattle stopper. This hitch tightener won’t change the look of your ride.
Easy to Install: Our Trailer Hitch Anti-Rattle Hitch Silencer takes only minutes to install, Just peel and apply to your clean drawbar, The durable silencing material stays in place (Note: In order to protect the hitch receiver shim from scratches during transportation, we installed a protective film on the side without adhesive. Before using the gasket, remove the protective film.)
Quiet Ride : No matter where you’re headed with a trailer in tow, the trip will be more enjoyable without the rattle, Other stabilizers require tools and loose parts to keep up with, every time you install/remove your drawbar, Unlike other anti-rattle stabilizers, this one’s easy and quick, Peel and stick once to reduce the rattle for good, Say goodbye to distracting noises by installing the best anti rattle hitch device for towing.
Simple Solution: There’s no need to waste time with spare parts and tools every time you want to insert or remove your trailer hitch. No trailer hitch clamp needed, Our trailer hitch silencer for 2" hitch, Before installing the draw bar silencer shims, be sure that your draw bar is both clean and dry, otherwise the adhesive is prone to failure. if not clean, wipe it down with rubbing alcohol, then allow to dry completely.
Maksim
2025-08-15 17:38:29
Of you need to fix your play- best solution. Make sure you try it after doing 2 sides. Don't use all 4 before you try. For me one on top and one on the side worked as needed. No nose no play. Who can't use it are just having small brain
BlindedbyScience
2025-08-10 16:12:54
Despite my Isopropyl Alcohol clean/dry the edges popped up.. A new hitch. Adhesion failure included 100% adhesive transfer.. so, poor adhesion to the plastic.Not 3Ms best effort..
T. Carlton
2025-07-01 11:10:45
After putting both 'A' pieces on, I couldn't insert the draw bar into the receiver. Had to remove one of them and remove the side wings of the other to fit into the receiver. Not the outcome I'd hoped for, still a good product.
Gregski777
2025-05-15 15:20:48
When applied to my hitch mount, as instructed, the hitch would not fit into the receiver. If you take either the top or the bottom pad off, then the product does not stop the rattling. I subsequently bought a Tri-max hitch clamp that works flawlessly. It’s hard to imagine the situation where this would be the better solution.
Ronald
2025-05-08 18:29:49
I used this in receiver to reduce rattle on the hitch!
Customer
2025-05-02 17:39:32
I put all pieces on then could not get it in the receiver. I had to take pieces off . Still wiggles around.
Flick
2025-04-16 12:08:00
Plastic pieces don't stay in place, and shred apart when inserting hitch.
SLA
2025-01-30 10:21:04
Tore apart during removal and unusable after three cycles
Johnny P
2024-11-30 15:10:41
I ended up returning this, it isn’t fit for purpose as many other comments suggest.
Recommended Products
