Your cart is empty.
Your cart is empty.Trim seal Vertical Bulb (large bulb) Lock Seal (Trunk Seal) 0.87" Bulb Height X 0.039" to 0.22" Grip Range (5 Feet) This is lock seal with vertical bulb that installs on the metal edges and under the trunk lid to prevent vibration, noise and leakage. All details about the install place, dimensions, and flexibility is clarified in the pictures. You can select the suitable trunk rubber seal for your vehicle by the dimensions. You can compare this car boot seal dimensions and your old boot seal dimensions. The dimensions: The dimensions available in millimeters and inch. The dimensions in inch: Height: 7/8" Edge Height: 72/64" Edge thickness: 7/32" Length: 5' The dimensions in millimeters: Height: 14 M.M. Edge Height: 10.9 M.M. Edge thickness: 5.5 M.M. Grip range: 1.5 to 4.0 M.M. Length: 1.55 Meter Materials: EPDM/METAL. Order code: C013-5F The install place: - On the trunk metal edge under the trunk lid. This product also designed to be: - Vans boot rubber seal. - Seal rubber for bus trunk. - Rubber stripe for the metal boxes. - Rubber seal for electric boards. - Trunk weather stripe for Car. - Door seal for metal boxes. - Caravan door weather seal. - Weatherstripping for Trailer. - Anti water rubber seal. - Door seal rubber for campers. - Heavy equipments rubber seal. - Rubber strip for motor lid. - Cap for metal sheet. - And more. Features: - Large bulb. - Large grip range. - High quality manufacture. - High quality materials. - The dimensions is suitable for most cars. - Contain internal metal clips to grip permanent around the install place. - very flexible. - Easy install. ( Just push on the rubber seal above the install place. the rubber seal will be griping around the edge without adhesive or any other thing). Benefits: - Prevent leaks, gaps and vibration. - Prevent leakage of air conditioner to out. - Prevent entry of dust, air and rain water. - Prevent noise. - Cover the sharp metal edges in the cars and the home.
Eldon Hower
September 2, 2025
does the job .. I am happy ...
Jonathan
July 5, 2025
Used this on a Land Rover Discovery 2 AC inlet to guard against water ingress. Fits perfectly and is designed well.
Cody Kryznel
June 15, 2025
Ordered the 15ft length and it was the perfect size for the rear lift gate on my 98 Cherokee, only had to trim about 6 inches off. Lift gate now shuts with a nice tight seal.
Girgis
April 6, 2025
Not same original
Robert L Kidd
March 28, 2025
Had it on about three years now. Still holding up.
SEAN HENNIGAN
March 13, 2025
Really helped seal the door and it seems like the hatch latches more securely.
Cap19686
February 14, 2025
The quality is good. Flexibility is good. Easy installation.
gfunkmasterflex
January 5, 2025
Factory trunk seal was like $160ish at the time I purchased this. Saved me quite a bit of money. I had to get weather-stripping adhesive to both ensure it was glued down but also to bond the two sections together. Also, my factory trunk seal had some small foam pieces that were inserted in certain places inside of the seal to give it more strength. I saved these and tried my best to get them back in place but the one place it really came in handy to save those pieces, was when bonding the two ends together. I trimmed the ends to be perfectly even, put some adhesive inside each end and then slid the foam in one side half of the way and then slid the other end inside the foam. It gave the seam some rigidity, prevented the ends from sliding or moving and made it just that much better of a bond. Work fast with the adhesive because it sets very quickly once outside of the tube.
Recommended Products
